首页> 外文期刊>Combustion and Flame >Combustion of nanoaluminum at elevated pressure and temperature behind reflected shock waves
【24h】

Combustion of nanoaluminum at elevated pressure and temperature behind reflected shock waves

机译:反射冲击波后在高压和高温下燃烧纳米铝

获取原文
获取原文并翻译 | 示例
           

摘要

This study presents experimental measurements on the combustion of nanoaluminum particles behind reflected shock waves in a shock tube. These experiments were performed at elevated pressures (4-32 atm) and temperatures (1200-2100 K) in the oxidizers oxygen and carbon dioxide, with nitrogen also present. The light emission from the reacting particles was monitored. For all cases, a brief period of intense light emission was observed soon after exposure to the reflected shock conditions. The time scales of this emission event are quantified by the 10-90% integrated emission intensity method to yield a reaction time for this rapid exothermic process. The duration of the emission is found to be 50-500 μs for the conditions tested here. Reaction times in 50% O_2 and 50% N_2 were shown to decrease significantly with ambient temperature, with Arrhenius-type exponentials fitting reasonably well to the observed experimental data. The reaction times were also dependent on pressure, with the timescales decreasing by 1.6-4 times as the pressure was increased from 8 to 32 atm over the range of temperatures in the experiments. In 50% CO_2 and 50% N_2, the reaction occurs in two sequential stages, with more of the emission at earlier times under higher-temperature conditions. Particle temperatures were also measured. During the bright emission event, the temperature rises above the ambient and then cools to near the ambient as the emission event ends. The peak temperature of the particle varied with ambient temperature, pressure, and oxidizer, with high ambient temperatures (2000 K), high pressures (32 atm), and high oxygen mole fractions (50%) giving the highest particle temperatures (~3500 K). Conversely, 50% CO_2 atmospheres produced particle temperatures just slightly above the ambient. The spectral output of the light emission was shown to be dominated by broadband emission. At high temperatures and pressures in oxygen, weak emission from the AlO B- X transition was observed.
机译:这项研究提出了在反射管中反射的冲击波后面的纳米铝颗粒燃烧的实验测量。这些实验是在氧化剂(氧气和二氧化碳)以及氮气中,在高压(4-32 atm)和温度(1200-2100 K)下进行的。监测反应颗粒的发光。对于所有情况,在暴露于反射冲击条件后不久,都会观察到短暂的强烈发光。该排放事件的时间尺度通过10-90%积分发射强度方法进行定量,以得出此快速放热过程的反应时间。对于此处测试的条件,发现发射持续时间为50-500μs。结果表明,在50%O_2和50%N_2中的反应时间随环境温度而显着减少,而Arrhenius型指数与观察到的实验数据相当吻合。反应时间还取决于压力,在实验温度范围内,随着压力从8 atm增加到32 atm,时间尺度减少了1.6-4倍。在50%CO_2和50%N_2中,反应分两个连续阶段进行,在较高温度条件下,更多的排放发生在较早的时间。还测量了颗粒温度。在明亮的发射事件期间,温度会升高到高于环境温度,然后随着发射事件的结束而冷却到接近环境温度。颗粒的峰值温度随环境温度,压力和氧化剂的变化而变化,具有较高的环境温度(2000 K),高压(32 atm)和较高的氧摩尔分数(50%),从而提供了最高的颗粒温度(〜3500 K) )。相反,50%CO_2气氛产生的颗粒温度略高于环境温度。发光的光谱输出显示为宽带发射所主导。在氧气中的高温和高压下,观察到AlO B-X跃迁的发射微弱。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号