...
首页> 外文期刊>Circuits, Devices & Systems, IET >Compact wide stopband microstrip diplexer with flat channels for WiMAX and wireless applications
【24h】

Compact wide stopband microstrip diplexer with flat channels for WiMAX and wireless applications

机译:具有平面通道的紧凑型宽固定微带器,用于WiMAX和无线应用

获取原文
获取原文并翻译 | 示例
   

获取外文期刊封面封底 >>

       

摘要

This study presents a compact wide stopband microstrip diplexer which is designed based on a novel resonator structure. This novel resonator consists of a main hairpin cell loaded by a smaller hairpin and T-shaped cells. The presented diplexer operates at 3.46 and 4.75 GHz for IEEE 802.16 worldwide interoperability for microwave access (WiMAX) and IEEE802.11a Wireless LAN applications, respectively. The main advantages of the proposed diplexer are its flat channels, two wide bandwidths, attenuated harmonics, low insertion losses better than 0.18 dB, several transmission zeros and sharp frequency response. From first up to fifth harmonics of the proposed diplexer are well attenuated with the maximum harmonic level -20 dB. Meanwhile, the simulation results show that the presented design can suppress harmonics up to 44 GHz. In other words, the harmonics from the 1st up to 12th are suppressed. The group delay at both channels is lower than 1.1 ns, which is good for a microstrip diplexer. This good performance is obtained, while the overall area of the designed diplexer is only 0.037 lambda(2)(g). Based on the comparison results, the proposed diplexer has a compact size, the minimum group delay and a wide stopband rejection. The proposed diplexer is fabricated and measured. Both simulation and measurement results are in good agreement.
机译:本研究介绍了一种紧凑的宽固定微带器,其基于新颖的谐振器结构设计。该新型谐振器包括由较小的发夹和T形细胞负载的主要发夹细胞。当前的双工器分别在3.46和4.75GHz上为IEEE 802.16为微波访问(WiMAX)和IEEE802.11a无线LAN应用程序的IEEE 802.16。所提出的双工器的主要优点是其平板通道,两个宽带宽,减速谐波,低插入损耗优于0.18 dB,多个传输零和尖锐频率响应。从第五到第五个谐波的所提出的双工器很好地衰减,最大谐波水平-20 dB。同时,仿真结果表明,所示的设计可以抑制高达44 GHz的谐波。换句话说,从第1到第12次的谐波被抑制。两个通道的组延迟低于1.1ns,这对于微路双工器有利。获得这种良好的性能,而设计的双工器的整体区域仅为0.037λ(2)(g)。基于比较结果,所提出的双工器具有紧凑的尺寸,最小组延迟和宽的阻带抑制。制造和测量所提出的双工器。仿真和测量结果都非常一致。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号