首页> 外文期刊>Australasian physical & engineering sciences in medicine >Development of a 3-D convolution / superposition algorithm for precise dose calculation in the skull
【24h】

Development of a 3-D convolution / superposition algorithm for precise dose calculation in the skull

机译:开发3D卷积/叠加算法以精确计算头骨中的剂量

获取原文
获取原文并翻译 | 示例
获取外文期刊封面目录资料

摘要

In this paper an algorithm for calculating 3-D dose distributions within the brain is introduced and adapted to the demands of modern radiosurgery. The dose calculation with this model is based on a 3-D distribution of the primary photon intensity which is calculated with a ray casting algorithm. A prelocated matrix takes into account field sizes as well as modifying elements as collimator positions (MLC), blocks, wedges and compensators. Monte Carlo precalculated monoenergetic kernels from 0.1 MeV to 50 MeV were at our disposal. The components of the spectrum were either determined by deconvoluting depth dose curves measured in water or analyzed with a Ge-Li detector system in the case of ~(60)Co. The calculated fluence distribution has to be superposed to the complete kernel containing the spatial energy deposition. Inhomogeneities and tissue interface phenomena (ρ_e, Z) have been investigated. The divergence of the rays and the curved surface of the patient are taken into account. Assuming homogenous media, it is possible to shorten the computation time by using the Fast Fourier Transformation (FFT) delivering a first overview within seconds. The algorithm was evaluated and verified under specific conditions of small fields as used in radiosurgery and compared to dose measurements and Monte Carlo calculations. In using both the fast algorithm (FFT) for mainly homogenous conditions on one hand and the very precise superposition for inhomogeneous cases on the other, this algorithm can be a very helpful instrument especially for critical locations in the skull.
机译:在本文中,介绍了一种用于计算脑内3-D剂量分布的算法,并使其适应现代放射外科的需求。该模型的剂量计算基于一次光子强度的3-D分布,该分布是通过射线投射算法计算的。预先放置的矩阵考虑了字段大小,并修改了诸如准直仪位置(MLC),块,楔形和补偿器之类的元素。我们可以处理从0.1 MeV到50 MeV的Monte Carlo预先计算的单能内核。光谱的成分可以通过在水中测得的去卷积深度剂量曲线来确定,或者在〜(60)Co的情况下使用Ge-Li检测器系统进行分析。计算出的注量分布必须叠加到包含空间能量沉积的完整核中。已经研究了不均匀性和组织界面现象(ρ_e,Z)。考虑射线的发散和患者的弯曲表面。假设介质是同质的,则可以通过使用快速傅立叶变换(FFT)在几秒钟内提供第一张概览图来缩短计算时间。对该算法进行了评估,并在放射外科手术中使用的特定小场条件下进行了验证,并将其与剂量测量和蒙特卡洛计算进行了比较。一方面将快速算法(FFT)用于主要均匀的条件,另一方面将非精确情况用于非常精确的叠加,该算法可以是非常有用的工具,尤其是在头骨的关键位置。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号