Low-Rise 3D Panel Structures for Hot Regions: Design Guidelines and Case Studies

摘要

More than 40 years ago, lightweight composite panels fabricated from polystyrene, steel, and shot-crete concrete were used to construct nonload-bearing walls such as partition walls and facade cladding. Recently, many private companies all over the world have started manufacturing these panels commercially to be used as load-bearing walls or floor slabs in the construction of low-rise structures up to three stories high by proposing a new building system called a "3D panel building system." The light weight of these panels, along with the fact that they are easy to handle, enhance the speed of construction, offer good heat insulation properties, and they cost less by avoiding the need for either formwork or skilled workers, make it an acceptable construction practice. Tests reported in the literature indicate that the degree of heat insulation of a 3D panel wall significantly exceeds that of partitions or curtain walls obtained with the traditional systems. This produces energy savings equal to 40% with both heating and cooling, making these panels suitable for construction in hot regions and especially in rural areas. In the literature, there are several reports of experimental works conducted by the author and by many researchers worldwide in an effort to determine the mechanical properties of the panels and to investigate the efficiency of its building system in terms of resistance to gravity and seismic loads. However, there is not enough information on their design rules. In this paper, some design guidelines are proposed. The guidelines rely on experimental findings and on reinforced concrete (RC) design building codes such as ACI-318 [Building Code Requirements for Reinforced Concrete (ACI 318-95), American Concrete Institute] and UBC. Two design case studies in Turkey using the proposed guidelines are presented. The first case is the design of a small 3D panel house and the second case is the design of a 3D panel factory. The proposed design rules are conservative and follow the rules specified for designing reinforced concrete structures with some modifications.