...
首页> 外文期刊>Applied Surface Science >Structural and thermodynamic characterization of modified cellulose fiber-based materials and related interactions with water vapor
【24h】

Structural and thermodynamic characterization of modified cellulose fiber-based materials and related interactions with water vapor

机译:改性纤维素纤维基材料的结构和热力学表征以及与水蒸气的相关相互作用

获取原文
获取原文并翻译 | 示例

摘要

In this study, the surface characteristics, water vapor interactions, and state of water adsorbed on unmodified and coated paper samples were investigated in an attempt to obtain a better understanding of the fundamental principles related to thermodynamics of this process, as well as to provide essential insight that could be used for further improvement of the papers' barrier properties. Based on the BET measurement, the coated paper samples showed higher specific surface areas than unmodified paper; however, their mean pore diameters are smaller. The BJH method was used for pore size distribution analysis. Hydrophobic properties of the paper samples were determined from experimental isotherms, e.g., monolayer moisture content, and these results have been related to the water vapor transfer rates (WVTRs) showing a complex nature of these relations. The highest peak corresponding to the modified samples with smaller pore sizes was found to be in the range of 1-30 nm, while it was in the 30-100 nm pore size range for unmodified paper. The net isosteric heats of sorption for different unmodified and modified paper samples were determined from water vapor adsorption isotherms measured at 15, 25, and 35 degrees C. The net isosteric heats of sorption decreased with an increase of moisture content after reaching the maximum values at 12.53, 15.25, 14.71, 23.2, and 22.77 kJ/mol for unmodified, zein grafted, calendered coated, PLA, and PHBV coated papers, respectively. The state of adsorbed water and water-vapor interaction on paper surface were also studied by TGA-DSC and FT-IR spectroscopic techniques. The FT-IR results revealed the formation of water vapor clusters due to poly-layer formation at the higher relative humidity. This has a profound effect on the equilibrium properties, e.g., the intensity of interactions between water molecules and the paper surface decreases as the relative humidity (moisture content) increases. Percentage of bound and unbound water formation and also the dehydration energy at various relative humidities were determined for the paper samples using the TGA-DSC technique. (C) 2015 Elsevier B.V. All rights reserved.
机译:在这项研究中,对未改性和涂布纸样品的表面特征,水蒸气相互作用和水吸附状态进行了研究,以期更好地了解与该过程的热力学有关的基本原理,并提供必要的信息。可用于进一步改善纸张阻隔性能的见解。根据BET测量,涂布纸样品比未改性纸显示出更高的比表面积;但是,它们的平均孔径较小。 BJH方法用于孔径分布分析。纸样品的疏水特性是根据实验等温线确定的,例如单层水分含量,这些结果与表明这些关系的复杂性的水蒸气传输速率(WVTR)有关。发现对应于具有较小孔径的改性样品的最高峰在1-30nm的范围内,而对于未改性的纸,其在30-100nm的孔径范围内。根据在15、25和35摄氏度下测得的水蒸气吸附等温线,可以确定不同的未改性纸和改性纸样品的净等温吸附热。当在25℃达到最大值后,净等规吸附热随着水分含量的增加而降低。对于未改性的玉米醇溶蛋白接枝,压光涂布,PLA和PHBV涂布纸,分别为12.53、15.25、14.71、23.2和22.77 kJ / mol。还通过TGA-DSC和FT-IR光谱技术研究了纸表面吸附水的状态和水蒸气的相互作用。 FT-IR结果表明,由于在较高的相对湿度下形成了多层结构,形成了水蒸气团簇。这对平衡特性产生了深远的影响,例如,水分子与纸张表面之间的相互作用强度随着相对湿度(水分含量)的增加而降低。使用TGA-DSC技术确定了纸样的结合水和非结合水的形成百分比以及各种相对湿度下的脱水能。 (C)2015 Elsevier B.V.保留所有权利。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号