首页> 美国卫生研究院文献>Polymers >Stability of Crystal Nuclei of Poly (butylene isophthalate) Formed Near the Glass Transition Temperature
【2h】

Stability of Crystal Nuclei of Poly (butylene isophthalate) Formed Near the Glass Transition Temperature

机译:在玻璃化转变温度附近形成的聚(间苯二甲酸丁二酯)晶体核的稳定性

代理获取
本网站仅为用户提供外文OA文献查询和代理获取服务,本网站没有原文。下单后我们将采用程序或人工为您竭诚获取高质量的原文,但由于OA文献来源多样且变更频繁,仍可能出现获取不到、文献不完整或与标题不符等情况,如果获取不到我们将提供退款服务。请知悉。

摘要

Tammann’s two-stage crystal-nuclei-development method is applied for analysis of the thermal stability of homogenously formed crystal nuclei of poly(butylene isophthalate) (PBI) as well as their possible reorganization on transferring them to the growth temperature, using fast scanning chip calorimetry. Crystal nuclei were formed at 50 °C, that is, at a temperature only slightly higher than the glass transition temperature, and developed to crystals within a pre-defined time at the growth temperature of 85 °C. The number of nuclei, overcritical at the growth temperature, was detected as a function of the transfer-conditions (maximum temperature, heating rate) by evaluation of the developed crystal fraction. For different size-distributions of crystal nuclei, as controlled by the nucleation time, there is detected distinct reduction of the nuclei number on heating to maximum temperatures higher than about 90 to 110 °C, with the latter value holding for longer nucleation time. Longer nucleation allows for both increasing the absolute nuclei number and generation of an increased fraction of larger nuclei. Heating at 1000 K/s to 140–150 °C causes “melting” of even the most stable nuclei. While direct transfer of crystal nuclei from the nucleation temperature (50 °C) to the growth temperature (85 °C) reveals negligible effect of the transfer-heating rate, in-between heating to higher temperatures is connected with distinct nuclei-reorganization above 85 °C on heating slower than 1000–10.000 K/s. The performed study not only provides specific valuable information about the thermal characteristics of crystal nuclei of PBI but also highlights the importance of proper design of Tammann’s nuclei development experiment for analysis of nuclei numbers. With the evaluation of critical rates of temperature-change for suppression of non-isothermal formation of both nuclei and crystals, the kinetics of crystallization of the slow crystallizing PBI is further quantified.
机译:塔曼(Tammann)的两阶段晶核发展方法用于分析聚间苯二甲酸丁二酯(PBI)均匀形成的晶核的热稳定性,以及在使用快速扫描芯片将其转移至生长温度时可能进行的重组。量热法。晶核在50°C(即仅略高于玻璃化转变温度的温度)下形成,并在85°C的生长温度下于预定时间内发展为晶体。通过评估形成的晶体分数,检测了在生长温度下超临界的核数与转移条件(最高温度,加热速率)的关系。对于成核时间控制的不同大小的晶核分布,在加热到最高温度约90至110°C时,可检测到晶核数明显减少,而后者的值保持更长的成核时间。较长的成核作用既可以增加绝对核数,又可以产生更大分数的更大核。以1000 K / s的速度加热到140–150°C,即使最稳定的原子核也会“熔化”。虽然晶核从成核温度(50°C)到生长温度(85°C)的直接转移显示出转移加热速率的影响可忽略不计,但在加热至更高温度的过程中,高于85°C的晶核重组明显加热速度低于1000–10.000 K / s时的°C。进行的研究不仅提供了有关PBI晶核热特性的具体有价值的信息,而且还强调了正确设计Tammann核发展实验对分析核数的重要性。通过评估临界温度变化率,以抑制核和晶体的非等温形成,进一步量化了慢结晶PBI的结晶动力学。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
代理获取

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号