首页> 美国卫生研究院文献>Journal of Biomedical Optics >Near-infrared imaging of demineralization on the occlusal surfaces of teeth without the interference of stains
【2h】

Near-infrared imaging of demineralization on the occlusal surfaces of teeth without the interference of stains

机译:牙齿咬合面上的脱矿物质的近红外成像不会产生污渍

代理获取
本网站仅为用户提供外文OA文献查询和代理获取服务,本网站没有原文。下单后我们将采用程序或人工为您竭诚获取高质量的原文,但由于OA文献来源多样且变更频繁,仍可能出现获取不到、文献不完整或与标题不符等情况,如果获取不到我们将提供退款服务。请知悉。

摘要

Most new caries lesions are found in the pits and fissures of the occlusal surface. Radiographs have extremely low sensitivity for early occlusal decay, and by the time the lesion is severe enough to appear on a radiograph, it typically has penetrated well into the dentin and surgical intervention is required. The occlusal surfaces are often heavily stained, and visual and tactile detection have poor sensitivity and specificity. Previous near-infrared imaging studies at wavelengths beyond 1300 nm have demonstrated that stains are not visible and demineralization on the occlusal surfaces can be viewed without interference from stains. The objective of our study is to determine how the contrast between sound and lesion areas on occlusal surfaces varies with wavelength from the visible to 2350 nm and determine to what degree stains interfere with that contrast. The lesion contrast for reflectance is measured in 55 extracted teeth with suspected occlusal lesions from 400 to 2350 nm employing silicon and indium gallium arsenide imaging arrays. In addition, the lesion contrast is measured on 25 extracted teeth with suspected occlusal lesions from 400 to 1600 nm in reflectance and from 830 to 1400 nm in transillumination before and after stains are removed using a ultrasonic scaler. The highest lesion contrast in reflectance is measured at wavelengths . Stains interfere significantly at wavelengths (400 to 1150) for both reflectance and transillumination measurements. Our study suggests that the optimum wavelengths for imaging decay in the occlusal surfaces are for reflectance (1700 to 2350 nm) and near 1300 nm (1250 to 1350 nm) for transillumination.
机译:大多数新的龋齿病变都在咬合面的凹坑和裂缝中发现。放射线照片对早期咬合衰减的敏感性极低,并且当病变严重到足以在放射线照片上出现时,它通常已经很好地渗透到牙本质中,因此需要手术干预。咬合表面经常被严重染色,视觉和触觉检测的敏感性和特异性均较差。先前在1300 nm以上的波长进行的近红外成像研究表明,污渍不可见,并且可以在没有污渍干扰的情况下查看咬合面上的脱矿物质。我们研究的目的是确定咬合表面上声音和病变区域之间的对比度如何随波长从可见光变化到2350 nm,并确定污渍在多大程度上干扰了该对比度。使用硅和铟镓砷化物成像阵列,对55颗拔牙后疑似咬合病变(从400到2350 nm)的反射率进行对比。此外,在使用超声波洁牙机去除污渍之前和之后,对25颗拔出的疑似咬合病变的牙齿测量了病变对比,反射率在400至1600 nm范围内,透射照度在830至1400 nm范围内。在波长处测量反射率的最高病变对比度。对于反射率和透照度测量,污渍会在波长(400至1150)处产生明显干扰。我们的研究表明,在咬合面成像衰减的最佳波长是用于反射(1700至2350 nm),而在1300 nm(1250至1350 nm)附近用于透射照明。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
代理获取

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号