首页> 美国卫生研究院文献>Applied and Environmental Microbiology >Effects of Incubation Time and Temperature on In Vitro Selective Delignification of Silver Leaf Oak by Ganoderma colossum
【2h】

Effects of Incubation Time and Temperature on In Vitro Selective Delignification of Silver Leaf Oak by Ganoderma colossum

机译:孵化时间和温度对灵芝古罗马银叶橡木体外选择性脱木素的影响

代理获取
本网站仅为用户提供外文OA文献查询和代理获取服务,本网站没有原文。下单后我们将采用程序或人工为您竭诚获取高质量的原文,但由于OA文献来源多样且变更频繁,仍可能出现获取不到、文献不完整或与标题不符等情况,如果获取不到我们将提供退款服务。请知悉。

摘要

The effects of incubation time and temperature on the ability of isolates of the chlamydosporic and thermophilic fungus Ganoderma colossum (Fr.) C. F. Baker to cause selective delignification of Quercus hypoleucoides A. Camus were evaluated by standard in vitro agar block tests. Chemical and scanning electron microscopy studies of decayed wood were used to determine the extent of selective delignification or simultaneous decay caused by each fungal isolate. At 35 deg C, the percent weight loss increased from 6.1% after 4 weeks to a maximum of 32.5 to 33.0% after 16 and 20 weeks of incubation. The average percent Klason lignin-chlorite holocellulose ratios (PKL/CHC) decreased from 0.35 in the control wood block to 0.22 in wood blocks incubated for 12 weeks; this indicated selective delignification. The average PKL/CHC increased for the 16- and 20-week incubation periods, indicating greater removal of polysaccharides during longer incubation periods. In temperature studies, the percent weight loss after 12 weeks was 26 to 27% between 30 and 40 deg C and less than 16% for the 25 and 45 deg C treatments. The average PKL/CHC ranged from 0.18 to 0.16 between 35 and 40 deg C, whereas they were 0.23 and 0.31 for the 25 and 45 deg C treatments, respectively. Scanning electron microscopy confirmed an optimum temperature range near 35 to 40 deg C and incubation times of 8 to 12 weeks for selective delignification. Under these conditions, ray parenchyma, fiber tracheids, and vessels were devoid of middle lamella; pit regions of cells were visible with significantly enlarged apertures; and individual cells were separated and clearly delimited. Extensive delignification of wood occurred throughout the wood blocks evaluated. Incubation times longer than 12 weeks resulted in greater degradation of wood cell walls and thus in greater removal of the polysaccharide component of the wood. For incubation times of 4 weeks or a temperature of 25 deg C, limited to no degradation of cells was observed. At 45 deg C, walls of fiber tracheids were eroded and ray parenchymal cells were extensively degraded, indicating that simultaneous degradation of cell walls occurred. Thus, the incubation temperature influenced the type of decay by G. colossum observed on oak wood blocks: extensive selective delignification at 35 to 40 deg C after more than 8 weeks of incubation or simultaneous decay at 45 deg C with 14% weight loss after 12 weeks of incubation. Isolates of G. colossum may prove useful in studies on mechanisms of delignification and biotechnological applications (e.g., biopulping) of lignin-degrading fungi.
机译:孵育时间和温度对衣原体和嗜热真菌灵芝(Fr.)C.F.Baker分离物引起拟南芥A.Camus选择性脱木质素能力的影响通过标准的体外琼脂封闭试验进行评估。使用化学和扫描电子显微镜研究腐烂的木材,以确定每种真菌分离物引起的选择性去木质素或同时腐烂的程度。在35℃下,体重减轻的百分比从4周后的6.1%增加到孵育16周和20周后的最大值32.5%至33.0%。 Klason木质素-亚氯酸盐全纤维素的平均百分率(PKL / CHC)从对照木块中的0.35降至培养12周的木块中的0.22;这表明选择性脱木素。在16和20周的潜伏期中,平均PKL / CHC升高,这表明在较长的潜伏期中,多糖的去除率更高。在温度研究中,在30到40摄氏度之间12周后体重减轻的百分比为26%至27%,而在25到45摄氏度的治疗中小于16%。在35至40摄氏度之间,平均PKL / CHC范围为0.18至0.16,而在25和45摄氏度的处理中,它们的平均值分别为0.23和0.31。扫描电子显微镜证实,选择性脱木质素的最佳温度范围为35至40℃,孵育时间为8至12周。在这种情况下,射线薄壁组织,纤维性气管和血管没有中层。可见细胞的凹坑区域,孔明显增大;各个单元被分离并明确界定。整个评估的木块中都发生了木材的广泛脱木质作用。孵育时间超过12周会导致木质细胞壁的降解程度更大,从而使木材中的多糖成​​分去除率更高。对于4周的温育时间或25℃的温度,观察到仅限于没有细胞降解。在45℃,纤维管胞的壁被侵蚀并且射线实质细胞被大量降解,表明细胞壁同时发生降解。因此,温育温度影响了在橡木块上观察到的由罗马球菌引起的腐烂类型:温育超过8周后,在35至40摄氏度下进行广泛的选择性去木质素作用,或者在45摄氏度下同时腐烂,同时12秒钟后重量减少14%孵化几周。罗马球菌的分离物可能被证明对木质素降解真菌的去木质化机理和生物技术应用(例如生物制浆)的研究有用。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
代理获取

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号