Increased density and coverage uniformity of viruses on a sensor surface by using U-type T-type and W-type microfluidic devices

摘要

Microorganisms, molecules, or viruses in the fluidic environment are usually at considerably low Reynolds numbers because of small diameters. The viscous forces of molecules and viruses dominate at considerably low Reynolds numbers. This study developed three microfluidic devices, that is, T type, U type, and W type devices, to control the flow movement, which can increase the adhesion density of viruses on the surface of the sensor. The linker 11-mercaptoundecanoic acid (11-MUA) and Turnip yellow mosaic virus (TYMV) were used in this study and measured by a confocal microscope. Fluorescent intensity and coverage of 11-MUA and TYMV were used to identify the adhesion density quantitatively. Results indicate that 11-MUA layers and TYMV disperse randomly by the dipping method. Attachment tests for T-, U-, and W-type devices demonstrated average fluorescence intensities of 1.56, 2.18, and 2.67, respectively, and average fluorescence coverage of 1.31, 1.87, and 2.55 times those of dipping techniques, respectively. The T-type device produced the lowest fluorescence coverage uniformity (10%–80%), whereas the W-type device produced the highest fluorescence coverage uniformity (80%–90%). Fluorescence intensity correlates positively with flow within a specified flow range; however, the exact relationship between fluorescence intensity and flow requires further study. Attachment tests for TYMV virus samples indicated that the W-type device produced an average fluorescence intensity of 3.59 and average fluorescence coverage of 19.13 times greater than those achieved through dipping techniques. Traditional immersion methods achieved fluorescence coverage of 0%–10%, whereas that of the W-type device reached 70%–90%.