首页> 美国卫生研究院文献>European Spine Journal >Primary stabilizing effect of interbody fusion devices for the cervical spine: an in vitro comparison between three different cage types and bone cement
【2h】

Primary stabilizing effect of interbody fusion devices for the cervical spine: an in vitro comparison between three different cage types and bone cement

机译:椎间融合器对颈椎的主要稳定作用:三种不同笼型和骨水泥的体外比较

代理获取
本网站仅为用户提供外文OA文献查询和代理获取服务,本网站没有原文。下单后我们将采用程序或人工为您竭诚获取高质量的原文,但由于OA文献来源多样且变更频繁,仍可能出现获取不到、文献不完整或与标题不符等情况,如果获取不到我们将提供退款服务。请知悉。

摘要

Interbody fusion cages are small hollow implants that are inserted into the intervertebral space to restore physiological disc height and to allow bony fusion. They sometimes cause clinical complications due to instability, subsidence or dislocation. These are basic biomechanical parameters, which influence strongly the quality of a fusion device; however, only few data about these parameters are available. Therefore, the purpose of the present study was to investigate the primary stabilizing effect of four different cervical fusion devices in in vitro flexibility tests. Twenty-four human cervical spine segments were used in this study. After anterior discectomy, fusion was performed either with a WING cage (Medinorm AG, Germany), a BAK/C cage (Sulzer Spine-Tech, USA), an AcroMed cervical I/F cage (DePuy AcroMed International, UK) or bone cement (Sulzer, Switzerland). All specimens were tested in a spine tester in the intact condition and after implantation of one of the four devices. Alternating sequences of pure lateral bending, flexion-extension and axial rotation moments (± 2.5 Nm) were applied continuously and the motions in each segment were measured simultaneously. In general, all tested implants had a stabilizing effect. This was most obvious in lateral bending, where the range of motion was between 0.29 (AcroMed cage) and 0.62 (BAK/C cage) with respect to the intact specimen (= 1.00). In lateral bending, flexion and axial rotation, the AcroMed cervical I/F cages had the highest stabilizing effect, followed by bone cement, WING cages and BAK/C cages. In extension, specimens fused with bone cement were most stable. With respect to the primary stabilizing effect, cages, especially the AcroMed I/F cage but also the WING cage and to a minor extent the BAK/C cage, seem to be a good alternative to bone cement in cervical interbody fusion. Other characteristics, such as the effect of implant design on subsidence tendency and the promotion of bone ingrowth, have to be determined in further studies.
机译:椎间融合器笼是小的空心植入物,可插入椎间隙,以恢复生理椎间盘高度并允许骨融合。它们有时由于不稳定,下沉或脱位而引起临床并发症。这些是基本的生物力学参数,这些参数会严重影响融合设备的质量;但是,关于这些参数的数据很少。因此,本研究的目的是研究四种不同的颈椎融合器在体外柔韧性测试中的主要稳定作用。在这项研究中使用了二十四个人的颈椎节段。前椎间盘切除术后,可通过WING笼(德国Medinorm AG),BAK / C笼(美国Sulzer Spine-Tech),AcroMed颈椎I / F支架(英国DePuy AcroMed International)或骨水泥进行融合(瑞士苏尔寿)。所有样品均在脊柱测试仪中完好无损并在植入四个装置之一后进行测试。连续施加纯横向弯曲,屈伸和轴向旋转力矩(±2.5 Nm)的交替顺序,并同时测量每个节段中的运动。通常,所有测试的植入物均具有稳定作用。这在横向弯曲中最为明显,相对于完整的样本(= 1.00),运动范围在0.29(AcroMed笼)和0.62(BAK / C笼)之间。在横向弯曲,屈曲和轴向旋转中,AcroMed颈椎I / F笼具有最高的稳定作用,其次是骨水泥,WING笼和BAK / C笼。此外,与骨水泥融合的标本最稳定。关于主要的稳定作用,在颈椎椎间融合术中,保持架,尤其是AcroMed I / F保持架,还有WING保持架,以及BAK / C保持架,在较小程度上似乎是骨水泥的良好替代品。其他特征,例如植入物设计对下陷趋势的影响和骨向内生长的促进,必须在进一步研究中确定。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
代理获取

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号