首页>
中文期刊>
《金属学报:英文版》
>Microstructure and Properties of 7075Al Alloy Fabricated by Directly Combined of Spray Forming and Continuous Extrusion Forming under Different Atomization Gas Pressures
Microstructure and Properties of 7075Al Alloy Fabricated by Directly Combined of Spray Forming and Continuous Extrusion Forming under Different Atomization Gas Pressures
A new process consisting of the spray forming and the continuous extrusion forming for manufacturing 7075Al alloy was proposed.The microstructure evolution,mechanical properties and the resistance to stress corrosion cracking of the alloy were studied.The results indicate that the spray forming process induces obviously grain refinement and greatly lower segregation microstructure.Besides,the Conform process produces finer grains and conduces to more uniform distribution of the precipitates of Al Cu and MgZn_2 phases.The fabricated alloy shows good comprehensive mechanical properties and superb performance of stress corrosion resistance.Moreover,a better combination of the mechanical properties and the resistance to stress corrosion cracking could then be obtained under a certain condition of atomization gas pressure of 0.19 MPa.The enhanced properties are attributed to the following factors,which include the grain refinement,the fine and homogeneous distribution of Al Cu and MgZn_2 phases,the high density of the extruded products,as well as the discontinuous distribution of the grain boundaries after retrogression and reaging(RRA)heat treatment.
展开▼