The optimal matching of a propeller to the hull and the diesel engine of the combine diesel or gas (CODOG) system is a critical design analysis in ship building. In this research work, a controllable Pitch Propeller (CPP) was considered whereby the pitch was varied, but only the extreme pitch set the limit of operation and matching was done with the extreme pitch condition. It considers the performance analysis of the propeller, the hull and the engine both in design and off design conditions. Without propulsion a vessel built cannot move and so choosing the right propeller to match the hull and engine is very vital. The various processes involved in the matching of the propeller to the diesel engine and hull of the vessel are considered, in order to achieve optimal performance of the vessel. A Java program (prop-matching) was developed to facilitate the matching process. The graphs obtained are used to determine the matching point at corresponding speed and power. The thrust and torque developed under different conditions as well as their significance, considering the fact that the propeller is a CPP. The engine response in transient conditions in reaction to the turbo charger was considered, the matching graph of the turbo charger compressor was discussed, and the calculated mass flow rate with various engine speeds and boost pressure were also discussed. This program was further used in matching the propeller to the hull and diesel or gas engines of a F90 frigate. The corresponding propeller rpm and engine power with pitch ratios from the program were similar to those from the design of the frigates. The various thrust and torque coefficients and open water efficiency all correspond to the simulated results of those of the naval frigate.
展开▼
