Combating Corrosion in Transmission Pipelines in Marine Environment Using Vernomia Amydalina as Inhibitor

摘要

Pipelines are system of pipes designed to transport liquids, gases or solid/ liquid mixtures over long distances. Some are used for domestic, household and sewage purposes. Others are buried underground or submerged in water for transportation of natural oil and gas (O & G) products. In this work, the specimens had to be kept in a workable state and steps were taken to prepare each specimen: all cuts and sheared edges were ground out to prevent them from becoming sites for preferential attack. The finishing of the specimen surface with grit abrasive paper (sand paper) and rinsing of the specimens in distilled water were done. Then degreasing of specimen in acetone and air-dried were carried out. Upon drying, the specimens were immediately weighed to obtain their initial weights. Twelve specimens were used for the test as follows: 6 Aluminum (Al);and 6 mild steel (MS) samples. With a 2 M concentration of Vernomia Amydalina (VA) extract solution, the MS and Al samples were immersed in different plastic containers containing 400 ml of seawater with pH value of 7.25 with no (0%) inhibitor added to it. A 5% (400 ml) of the VA solution was poured into the measuring cylinder for each sample-Al and MS. The specimens were suspended by the strings and completely immersed in the different percentage test media. The same procedure was carried out for each of the different percentages, 10%, 15%, 20%, and 25% and a total of 12 solutions were set up. The experimental procedure used was that seawater of 7.25 pH was obtained from Abonnema water front of Rivers State. At the end of every week (168 hours), the specimens were removed from the corrosive media. Observation and recording of appearance of the specimen noting sites were done. Cleanings of specimen with white handkerchief or tissue paper were carried out and washing of specimen with distilled water, scrubbing of specimen with a soft brush and dipping the specimen into acetone after washing, it was removed to air-dry and weighed. It is observed that optimum inhibition of coupons was obtained between 15% - 25% of VA solution during the first four weeks of testing. At the fifth week the inhibitor was gradually losing its effectiveness. This means that more inhibitor need be added at regular intervals to sustain the effectiveness of the inhibitor.