Microstructural Evolution of Cast Hyper-Eutectic Al-18 Si Alloy during Cyclic Semi-Solid Heat Treatment

摘要

The cyclic semi-solid heat treatment represents a promising technique for improving microstructure and mechanical properties of a wide range of metallic alloys. In the current research the influence of cyclic semi-solid heat treatment on microstructure of Al-18% Si alloy containing 0.8% Fe has been studied. All specimens were heated in an electrically heated resistance furnace with heating rate of 10°C·min-1 to 585°C. For a complete one cycle heat treatment (5 min heating time), samples after 5 min holding at 585°C were cooled to a temperature of 550°C in still air cooling and the samples were taken out immediately for water quenching. It was found that heat treatment cycles should be limited to 3 cycles or less in order to maintain fine grain size and globular structure without agglomeration and coalescence. Cyclic semi-solid heat treatment changes morphology of iron-rich intermetallics phases to be plate-like and fine plate iron-rich intermetallics phases, in stead of needle-like iron-rich intermetallics phases that are observed in as-cast samples. Cyclic heating shows a relatively higher hardness for all heating cycles compared with as-cast one due to its finer and globular structure. Cyclic semi-solid heat treatment technique results in lower coarsening rate constant compared with isothermal heat treatment one due to coarsening discontinuous effect.