Laser-based directed energy deposition of novel Sc/Zr-modified Al-Mg alloys:columnar-to-equiaxed transition and aging hardening behavior

摘要

The control of grain morphology is important in laser additive manufacturing(LAM),as grain morphology further affects the hot cracking resistance,anisotropy,and strength–ductility synergy of materials.To develop a solidification-control solution and achieve columnar-to-equiaxed transition(CET)in Al-based alloys during LAM,Sc-and-Zr-modified Al-Mg alloys were processed via directed energy deposition(DED).CET was achieved by introducing high potent primary Al_(3)(Sc,Zr)nucleation sites ahead of the solidification interface.Furthermore,the relationship between the solidification control parameters and precipitation behavior of primary Al_(3)(Sc,Zr)nucleation sites was established using the time-dependent nucleation theory.Then,the CET was studied according to the Hunt criterion.The results indicated that coarse columnar grain structure was still obtained at the inner region of the molten pool at low Sc/Zr contents owing to the effective suppression of the precipitation of the primary Al_(3)(Sc,Zr)nucleation sites via rapid solidification during DED.In addition,the relatively low melt temperature at the fusion boundary unavoidably promoted the precipitation of primary Al_(3)(Sc,Zr)nucleation sites,which resulted in a fine equiaxed grains band at the edge of the molten pool.As the Sc/Zr content increased,the solidification cooling rate was not sufficient to suppress the precipitation of the primary Al_(3)(Sc,Zr)nucleation sites,and a fully equiaxed grain structure was obtained.Furthermore,the effect of the layer-by-layer manufacturing process on the subsequent precipitation strengthening of secondary Al_(3)(Sc,Zr)precipitates was discussed.Both the remelting and subsequent aging during thermal cycling should be considered to achieve greater precipitation strengthening.