首页> 外文会议>Prognostics and Health Management Conference >Research and Implementation of LRU-Based Flow Table Management for Onboard Switch
【24h】

Research and Implementation of LRU-Based Flow Table Management for Onboard Switch

机译:用于车载开关的LRU流量表管理的研究与实现

获取原文

摘要

In software defined networking (SDN), if a newly arriving flow does not match the rule in the flow table, the switch will send a message to the controller for further actions. Similarly, the flow-based onboard switch needs to interact with the network control center when an incoming flow does not match the flow entries in the flow table. At the same time, satellite network has less bandwidth, higher delay and strict hardware resource. To improve the efficiency of flow table management in the switch, an LRU-based flow table management circuit is designed in this paper. This design can fully utilize the storage of the flow table to enhance the flow entry matching rate and increase the active flow entry priority to reduce the matching time of the flow table. If the flow table storage is full when a new entry comes, it deletes the oldest unmatched flow entry. Thus, the performance can be improved in the channel utilization and delay. The whole design is realized with Verilog HDL, simulated with Modelsim SE 10.2c in a Xilinx xc6vlx240t FPGA. And the simulation results indicate that the design can meet the corresponding requirements with little resource, which is suitable for onboard switch.
机译:在软件定义的网络(SDN)中,如果新到达的流量与流表中的规则不匹配,则交换机将向控制器发送消息以获取进一步的操作。类似地,当传入的流量与流动表中的流条目不匹配时,基于流的车载开关需要与网络控制中心交互。同时,卫星网络具有较少的带宽,更高的延迟和严格的硬件资源。为了提高开关中流动表管理的效率,本文设计了一种基于LRU的流量表管理电路。该设计可以充分利用流动表的存储来增强流入匹配速率,并提高主动流动进入优先级以减少流动表的匹配时间。如果在新条目到来时流量表存储已满,则删除最旧的无与伦比的流条目。因此,可以在信道利用率和延迟中提高性能。整个设计用Verilog HDL实现,用Xilinx XC6VLX240T FPGA中的Modelsim SE 10.2c模拟。仿真结果表明,该设计可以满足具有小资源的相应要求,适用于板载开关。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号