首页> 外文会议>Global Congress on Construction, Material and Structural Engineering >Shear Capacity of Reinforced Concrete Beams with Square Cross Section Subjected to Biaxial Bending
【24h】

Shear Capacity of Reinforced Concrete Beams with Square Cross Section Subjected to Biaxial Bending

机译:钢筋混凝土梁的剪切容量,方形横截面经受双轴弯曲

获取原文

摘要

This paper presents the test result of an experimental study on the shear strength of reinforced concrete beams subjected to biaxial loads.Six simply supported reinforced concrete beams with square cross section Were used.Three beams rotated at 22.5 degrees and three beams rotated at 45 degrees to the applied load were tested until failure.All beams were subjected to four-point bending test.The test variable in this study was ratio of longitudinal reinforcement.The values of flexural crack load,diagonal crack load and the ultimate load were observed during the test as well as the midpoint deflection of the beams.Existing empirical equation for shear strength of concrete presented in design codes was used and then compared to the values obtained from the test.Comparison between test results and theoretical shear capacity show that all of equations conservatively estimated the occurrence of shear failure with the values of the test results 25 to 55% higher than the theoretical values depending on the ratio of longitudinal reinforcement.It was also observed that ratio of longitudinal reinforcement influences the angle of diagonal shear crack.
机译:本文介绍了对经过双轴载荷的钢筋混凝土梁剪切强度的试验结果。使用具有方横截面的钢筋混凝土梁的剪切强度。三梁旋转在22.5度,三个梁以45度旋转三个梁旋转测试施加的载荷直至失效。对梁进行四点弯曲试验。本研究中的试验变量是纵向增强的比率。在测试期间观察到弯曲裂缝负荷,对角线裂缝负荷和最终负载的值。以及光束的中点偏转。使用了设计代码中呈现的混凝土的剪切强度的经验方程,然后与从测试结果中获得的值进行比较,测试结果与理论剪切容量之间的比较显示,保守估计的所有方程试验结果的剪切失效结果比理论值高25%至55%结束纵向加强件的比率。还观察到纵向加强件的比率影响对角线剪切裂纹的角度。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号