首页> 外文会议>Society of Petroleum Engineers International Heavy Oil Conference >Use of Acid Gas (CO2/H2S) for the Cyclic Solvent Injection (CSI) Process for Heavy Oil Reservoirs
【24h】

Use of Acid Gas (CO2/H2S) for the Cyclic Solvent Injection (CSI) Process for Heavy Oil Reservoirs

机译:使用酸性气体(CO2 / H2S)对重油储层的环状溶剂注入(CSI)方法

获取原文

摘要

Acid gas is a greenhouse gas (GHG) composed of (CO2/H2S). It is produced during oil, gas, and petrochemical operations. During the last several years, there has been an increasing pressure within the oil industry in Canada to further reduce GHG emissions. Another environmental problem within the oil industry comes from the elemental sulphur, which is converted from the H2S and is accumulated on the surface. Currently, there exist two technological solutions to deal with this challenge. The first one is acid gas injection into geological formations for sequestration purposes. This option has been developed in Canada over the last 22 years. The second one is the use of it for EOR operations in conventional oil reservoirs. This option has successfully been applied in Zama, a Canadian conventional oil reservoir. There is an interest within the oil industry again to evaluate the performance of CO2/H2S to also recover heavy oil during the Cyclic Solvent Injection (CSI) process. The CSI process has already shown success in improving heavy oil recovery after primary cold production (CHOPS) using pure solvents or (CO2 /propane or CH4/propane) mixtures. Consequently, if feasible, CO2/H2S injection for CSI could also contribute to increase the heavy oil recovery factor while eliminating the accumulation of sulphur on the surface and sequestering this greenhouse gas. The results of this work indeed demonstrated that the CO2/H2S mixture tested performs better for the CSI process than some of the conventional solvents previously tested i.e. pure CO2 or methane/propane mixture. Not only the recovery factor was better but also the oil recovery declined less with subsequent cycles by using CO2/H2S mixture rather than using pure CO2. It is important to mention though that the mixture of CO2/propane still shows the best performance in the series of solvents studied so far for the Cyclic Solvent Injection at Alberta Innovates Technology Futures.
机译:酸性气体是由(CO2 / H2S)组成的温室气体(GHG)。它是在石油,天然气和石化操作期间生产的。在过去的几年中,加拿大石油工业中的压力越来越大,以进一步减少温室气体排放。石油工业内的另一个环境问题来自元素硫,该元素硫从H 2S转化并积聚在表面上。目前,存在两种技术解决方案来处理这一挑战。第一个是酸气液注入地质形成以进行隔离目的。此选项已在过去22年中在加拿大开发。第二个是在传统的储油液中使用它在EOR操作中。该选项已成功应用于加拿大传统储油储层的ZAMA。在石油工业中兴趣再次评估CO2 / H2S的性能在环状溶剂注射(CSI)过程中还能恢复重油。 CSI过程已经表现出使用纯溶剂或(CO 2 /丙烷或CH4 /丙烷)混合物在原发性冷轧(CHOPS)后改善重油回收的成功。因此,如果可行,CSI的CO 2 / H 2 S注射也可能有助于增加重油回收率,同时消除表面上硫的积累并螯合该温室气体。这种工作的结果确实表明,CO 2 / H 2 S混合物测试进行更好的为CSI过程比一些常规溶剂的先前测试的即纯二氧化碳或甲烷/丙烷混合物。不仅恢复因子更好,而且通过使用CO 2 / H 2 S混合物而不是使用纯CO 2,随后的循环越来越少。重要的是要提及二氧化碳/丙烷的混合物仍然表现出迄今为止艾伯塔省循环溶剂注射研究的一系列溶剂中最佳性能的最佳性能。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号