首页> 外文会议>International Conference Petroleum Phase Behavior and Fouling >Stove Performance and Emission Characteristics in Residential Wood Log and Pellet Combustion, Part 1: Pellet Stoves
【24h】

Stove Performance and Emission Characteristics in Residential Wood Log and Pellet Combustion, Part 1: Pellet Stoves

机译:住宅木材日志和颗粒燃烧中的炉子性能和排放特性,第1部分:颗粒炉灶

获取原文

摘要

Stove performance, characteristics, and quantities of gaseous and particulate emissions were determined for two different pellet stoves, varying fuel load, pellet diameter, and chimney draft. This approach aimed at covering variations in emissions from stoves in use today. The extensive measurement campaign included CO, NO_x, organic gaseous carbon, volatile organic compounds (VOCs), polycyclic aromatic hydrocarbons (PAHs), total particulate matter (PM_(tot)) as well as particle mass and number concentrations, size distributions, and inorganic composition. At high load, most emissions were similar. For stove B, operating at high residual oxygen and solely with primary air, the emissions of PM_(tot) and particle numbers were higher while the particles were smaller. Lowering the fuel load, the emissions of CO and hydrocarbons increased dramatically for stove A. which operated continuously also at lower fuel loads. On the other hand for stove B, which had intermittent operation at lower fuel loads, the emissions of hydrocarbons increased only slightly lowering the fuel load, while CO emissions increased sharply, due to high emissions at the end of the combustion cycle. Beside methane, dominating VOCs were ethene, acetylene, and benzene and the emissions of VOC varied in the range 1.1-42 mg/MJ_(fuel). PAH emissions (2- 340μg/MJ_(fuel)) were generally dominated by phenanthrene, fluoranthene and pyrene. The PM_(tot) values (15-45 mg/MJ_(fuel)) were in all cases dominated by fine particles with mass median diameters in the range 100-200 nm, peak mobility diameters of 50-85 nm. and number concentrations in the range 4 x 10~(13) to 3 x 10~(l4) particles/MJ_(fuel). During high load conditions, the particulate matter was totally dominated by inorganic particles at 15-25 mg/MJ_(fuel) consisting of potassium, sodium, sulfur, and chlorine, in the form of K2SO4, K3Na(SO4)2, and KCl. The study shows that differences in operation and modulation principles for the tested pellet stoves, relevant for appliances in use today, will affect the performance and emissions significantly, although with lower scattering in the present study compared to compiled literature data.
机译:为两个不同的颗粒炉,不同的燃料载荷,颗粒直径和烟囱草案测定气态和微粒排放的炉子性能,特性和数量。这种方法旨在涵盖今天使用炉子排放的变化。广泛的测量运动包括CO,NO_X,有机气态碳,挥发性有机化合物(VOC),多环芳烃(PAH),总颗粒物质(PM_(TOT))以及粒子质量和数量浓度,尺寸分布和无机作品。在高负荷下,大多数排放都是相似的。对于炉子B,在高残留的氧气和仅针对初级空气的情况下操作,PM_(TOT)和颗粒数的排放较高,而颗粒较小。降低燃料负荷,CO和烃的排放速度显着增加了炉子A.连续操作也在较低的燃料载荷下运行。另一方面,对于在较低燃料载荷的炉子B处具有间歇性操作的炉子,烃的排放仅增加了燃料负荷略微降低,而CO排放急剧增加,由于燃烧循环结束的高排放量。除甲烷外,主导VOC是乙烯,乙炔和苯,VOC的排放在1.1-42 mg / mj_(燃料)范围内。 PAH排放(2-340μg/ mj_(燃料))通常由菲丙烯,氟和芘支配。 PM_(TOT)值(15-45mg / mJ_(燃料))在所有案例中,由含有100-200nm的质量中值直径的细颗粒,峰值迁移率直径为50-85nm。和数字集中在4×10〜(13)至3×10〜(L4)粒子/ MJ_(燃料)的范围内。在高负荷条件下,颗粒物质完全由15-25mg / mJ_(燃料)的无机颗粒,其由钾,钠,硫和氯,以K 2 SO 4,K3NA(SO 4)2和KCl的形式组成。该研究表明,测试颗粒炉的运行和调制原理的差异,与当今使用的电器相关,虽然与编译的文献数据相比,本研究中散射较低。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号