首页> 外文会议>SAE World Congress >Influence of Ethanol Content in Gasoline on Speciated Emissions from a Direct Injection Stratified Charge SI Engine
【24h】

Influence of Ethanol Content in Gasoline on Speciated Emissions from a Direct Injection Stratified Charge SI Engine

机译:直喷式电荷Si发动机对汽油含量对汽油含量的影响

获取原文

摘要

The influence of ethanol content in gasoline on speciated emissions from a direct-injection stratified charge (DISC) SI engine is assessed. The engine tested is a commercial DISC one that has a wall-guided combustion system. The emissions were analyzed using both Fourier transform infrared (FTIR) spectroscopy and conventional emission measurement equipment. Seven fuels were compared in the study. The first range of fuels was of alkylate type, designed to have 0, 5, 10 and 15% ethanol in gasoline without changing the evaporation curve. European emissions certification fuel was tested, with and without 5% ethanol, and finally a specially blended high volatility gasoline was also tested. The measurements were conducted at part-load, where the combustion is in stratified mode. The engine used a series engine control unit (ECU) that regulated the fuel injection, ignition and exhaust gas recirculation (EGR). A low concentration of ethanol in a commercial gasoline does not alter significantly the operational characteristics of the DISC engine tested. The engine-out hydrocarbon (HC) emissions are practically unchanged, while the carbon monoxide (CO) emissions decrease when 5% ethanol is added. The tailpipe HC, CO and nitrogen oxides (NO{sub}x) emissions are virtually unchanged for the fuel with 5% ethanol. However, for the alkylate fuels there was a tendency towards increased engine-out and tailpipe HC emissions with increased ethanol content. Aldehyde emissions, which could be measured only for the alkylate fuels, increased slightly when ethanol was added. Stratified charge aldehyde emissions were 2 - 3 times higher than for homogeneous charge operation.
机译:评估乙醇含量在汽油对直接喷射分层电荷(盘)Si发动机的指挥发射的影响。测试发动机是一种具有壁导燃系统的商业盘。使用傅里叶变换红外(FTIR)光谱和常规排放测量设备进行分析排放。在研究中比较了七种燃料。第一范围的燃料是烷基化型,设计成在汽油中具有0,5,10和15%乙醇而不改变蒸发曲线。欧洲排放认证燃料经过测试,有和没有5%乙醇,最后还测试了一种特别混合的高挥发性汽油。测量在部分负载下进行,其中燃烧处于分层模式。该发动机使用了串联发动机控制单元(ECU),该机控单元(ECU)调节燃料喷射,点火和废气再循环(EGR)。商业汽油中低浓度的乙醇不会显着改变圆盘发动机测试的操作特性。发动机输出烃(HC)排放实际上不变,而当加入5%乙醇时,一氧化碳(CO)排放减少。尾管HC,CO和氮氧化物(NO {Sub} x)排放几乎不变,燃料为5%乙醇。然而,对于烷基化燃料燃料,倾向于增加发动机输出和尾管HC排放量增加的乙醇含量。当加入乙醇时,仅可以针对烷基化燃料测量的醛排放量略有增加。分层电荷醛排放量高于均匀电荷操作的2-3倍。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号