In fluence on transient emissions at various injection timings, using cetane improvers, bio-diesel, and low aromatic fuels

摘要

A 260 kW DDC Series 60 heavy-duty diesel engine, calibrated for 1991-1993 emissions standards, was used to generate transient emissions data at three fuel injection timings, using several fuels. The fuel matrix evaluated in this study consisted of a high cetane, low aromatic diesel fuel meeting CARB specifications for on-highway use, and a typical low-sulfur (nominally 0.04 wt.%) type 2D diesel served as the "base" fuel. The base fuel was then treated with the two different cetane improvers ethyl hexyl nitrate (EHN) and di-tertiary butyl peroxide (DTBP). Base fuel was also blended with soy methyl ester to yield a bio-diesel product. The bio-diesel was tested with and without the DTBP additive. Except for the type 2D base fuel, which had a cetane number of 45, most fuels tested in this study had a cetane number of 55, either naturally or improved. Emission tests were conducted at baseline timing, then at 3 deg retard, and finally, at 5 deg retard. Particulate was characterized as carbon, ash, sulfate, and volatile organic fraction (VOF). The percent of VOF attributed to unburned lubricating oil was also quantified. The 2D base fuel resulted in the highest NO{sub}x and PM levels at each timing level tested in this study. Progressive timing retard reduced NO{sub}x and increase PM for all fuels tested; however, smaller increases in PM were observed when using the low aromatic fuel and the bio-diesel product. The low aromatic fuel had the lowest NO{sub}x level at each timing, but bio-diesel had the lowest PM. At retarded timings, increases in total PM levels were attributed to unburned fuel derived VOF and carbonaceous material.