首页> 外文会议>ASME Pressure Vessels and Piping Conference >ACOUSTICAL CHARACTERISTICS OF SINGLE AND TWO-PHASE HORIZONTAL PIPE FLOW THROUGH AN ORIFICE
【24h】

ACOUSTICAL CHARACTERISTICS OF SINGLE AND TWO-PHASE HORIZONTAL PIPE FLOW THROUGH AN ORIFICE

机译:单相水平管道流过孔口的声学特性

获取原文

摘要

In this work, the acoustic effects of horizontal air-water flow through an orifice are investigated experimentally. Single phase flow (air) and two-phase flow (air and water) tests are performed for two sets of orifices. One set of straight edged and one set of upstream rounded orifices. For each set, the diameters of the orifices were 2, 5, and 10mm, with a thickness of 5 mm. The two-phase flow is generated by injecting water at a rate of 0 to 40 g/s to air in a pipe with diameter of 25 mm. The air rate is fixed in the range from 5.8 to 14 g/s, where the upstream pressure varies from 1.5 to 4 bar at ambient temperature. Unsteady pressure fluctuations are recorded at two upstream and two downstream position. The valve noise standard NEN-EN-IEC (60534-8-3, 2011) for dry gas is assessed by means of experimental data in dry conditions at fixed air mass flow rate. Predictions of sound power spectra by means of the standard are found to be more accurate compared to those obtained following Reethof & Ward (1986), also in conditions of a choked orifice. In case of multiphase flow already at very low liquid fractions of much less than 1%, the standard is no longer valid. The frequency spectrum is no longer determined by the jet noise but starts to be dominated by low frequency general multiphase flow. The Strouhal number based on the jet conditions is an order lower than Sr = 0.2 indicating process variations rather than jet noise. Furthermore, at choking conditions the further expansion which occurs in single phase flow is likely different at multiphase flow. For non-choked flow, the standard can be adapted using multiphase mixture properties. This does lead to a good prediction. However at choked conditions, this method fails.
机译:在这项工作中,通过实验研究了水平空气流过孔的声学效应。对两组孔进行单相流(空气)和两相流(空气和水)测试。一套直边和一组上游圆形孔。对于每组,孔的直径为2,5和10mm,厚度为5mm。通过将水以0至40g / s的速率注入到直径为25mm的管道中的速率产生两相流。空气速率固定在5.8至14克/秒的范围内,其中上游压力在环境温度下从1.5到4巴不同。不稳定的压力波动记录在两个上游和两个下游位置。通过在固定空气质量流速下的干燥条件下的实验数据评估用于干燥气体的阀噪声标准NEN-EN-IEC(60534-8-3,2011)。与Reethof&Ward(1986)中获得的那些,发现声音功率谱通过标准的预测更准确,同样在窒息孔口的条件下。如果在非常低的液体分数下的多相流量小于1%的情况下,标准不再有效。频谱不再由射流噪声确定,但是开始以低频通用多相流量为主。基于喷射条件的Strouhal数量是低于SR = 0.2的顺序,表示过程变化而不是喷射噪声。此外,在窒息条件下,在单相流中发生的进一步膨胀可能在多相流中不同。对于非呼吸的流动,可以使用多相混合物性质来调整标准。这确实导致了良好的预测。然而,在Choked条件下,这种方法失败了。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号