首页> 外文会议>ASME Pressure Vessels and Piping conference >ACOUSTICAL CHARACTERISTICS OF SINGLE AND TWO-PHASE HORIZONTAL PIPE FLOW THROUGH AN ORIFICE
【24h】

ACOUSTICAL CHARACTERISTICS OF SINGLE AND TWO-PHASE HORIZONTAL PIPE FLOW THROUGH AN ORIFICE

机译:通过孔的单相和两相水平管道的声波特性

获取原文

摘要

In this work, the acoustic effects of horizontal air-water flow through an orifice are investigated experimentally. Single phase flow (air) and two-phase flow (air and water) tests are performed for two sets of orifices. One set of straight edged and one set of upstream rounded orifices. For each set, the diameters of the orifices were 2, 5, and 10mm, with a thickness of 5 mm. The two-phase flow is generated by injecting water at a rate of 0 to 40 g/s to air in a pipe with diameter of 25 mm. The air rate is fixed in the range from 5.8 to 14 g/s, where the upstream pressure varies from 1.5 to 4 bar at ambient temperature. Unsteady pressure fluctuations are recorded at two upstream and two downstream position. The valve noise standard NEN-EN-IEC (60534-8-3, 2011) for dry gas is assessed by means of experimental data in dry conditions at fixed air mass flow rate. Predictions of sound power spectra by means of the standard are found to be more accurate compared to those obtained following Reethof & Ward (1986), also in conditions of a choked orifice. In case of multiphase flow already at very low liquid fractions of much less than 1%, the standard is no longer valid. The frequency spectrum is no longer determined by the jet noise but starts to be dominated by low frequency general multiphase flow. The Strouhal number based on the jet conditions is an order lower than Sr = 0.2 indicating process variations rather than jet noise. Furthermore, at choking conditions the further expansion which occurs in single phase flow is likely different at multiphase flow. For non-choked flow, the standard can be adapted using multiphase mixture properties. This does lead to a good prediction. However at choked conditions, this method fails.
机译:在这项工作中,实验研究了水平空气流过孔的声学效果。对两组孔进行单相流(空气)和两相流(空气和水)测试。一组直边和一组上游倒圆孔。对于每组,孔的直径分别为2、5和10mm,厚度为5mm。两相流是通过将水以0到40 g / s的速度注入到直径为25 mm的管道中的空气中而产生的。空气速率固定在5.8至14 g / s的范围内,其中在环境温度下,上游压力在1.5至4 bar之间变化。在两个上游和两个下游位置记录了不稳定压力波动。干燥空气的阀门噪声标准NEN-EN-IEC(60534-8-3,2011)是通过在干燥空气条件下以固定空气质量流量进行的实验数据来评估的。与在Reethof&Ward(1986)之后获得的结果(在节流孔的情况下)相比,通过该标准进行的声功率谱预测更加准确。如果多相流的液体分数已经非常低,远低于1%,则该标准不再有效。频谱不再由喷射噪声确定,而是开始由低频通用多相流控制。基于喷射条件的斯特劳哈尔数是一个低于Sr = 0.2的量级,表明工艺有所变化,而不是喷射噪声。此外,在节流条件下,单相流中发生的进一步膨胀在多相流中可能有所不同。对于非阻流,可以使用多相混合物特性来调整标准液。这确实导致了良好的预测。但是,在阻塞的情况下,此方法将失败。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号