首页> 外文会议>ASME International Mechanical Engineering Congress and Exposition >The Influence of Neck Kinematics on Brain Pressures and Strains under Blast Loading
【24h】

The Influence of Neck Kinematics on Brain Pressures and Strains under Blast Loading

机译:颈部运动学对爆破载荷脑压力和菌株的影响

获取原文

摘要

Strains and pressures in the brain are known to be influenced by rotation of the head in response to loading. This brain rotation is governed by the motion of the head, as permitted by the neck, due to loading conditions. In order to better understand the effect neck characteristics have on pressures and strains in the brain, a human head finite element model (HHFEM) was attached to two neck FEMs: a standard, well characterized Hybrid III Anthropometric Test Device neck FEM; and a high fidelity parametric probabilistic human FEM neck that has been hierarchically validated. The Hybrid III neck is well-established in automotive injury prevention studies, but is known to be much stiffer than in vivo human necks. The parametric FEM is based on CT scans and anatomic data, and the components of the model are validated against biomechanical tests at the component and system level. Both integrated head-neck models were loaded using pressure histories based on shock tube exposures. The shock tube loading applied to these head models were obtained using a computational fluid dynamics (CFD) model of the HHFEM surface in front of a 6 inch diameter shock tube. The calculated pressure-time histories were then applied to the head-neck models. The global head rotations, pressures, brain displacements, and brain strains of both head-neck models were compared for shock tube driver pressures from 517 to 862 kPa. The intracranial pressure response occurred in the first 1 to 5 msec, after blast impact, prior to a significant kinematic response, and was very similar between the two models. The global head rotations and the strains in the brain occurred at 20 to 100 msec after blast impact, and both were approximately two times higher in the model using the head parametric probabilistic neck FEM (H2PN), as compared to the model using the head Hybrid III neck FEM (H3N). It was also discovered that the H2PN exhibited an initial backward and small downward motion in the first 10 ms not seen in the H3N. The increased displacements and strains were the primary difference between the two combined models, indicating that neck constraints are a significant factor in the strains induced by blast loading to the head. Therefore neck constraints should be carefully controlled in studies of brain strain due to blast, but neck constraints are less important if pressure response is the only response parameter of primary interest.
机译:已知脑中的菌株和压力是通过头部响应于装载而受到旋转的影响。由于负载条件,这种脑旋转受到头部的运动,如颈部所允许的。为了更好地理解颈部特性对大脑中的压力和菌株进行压力和菌株,将人头有限元模型(HHFEM)连接到两个颈部有限元:标准,表征杂交III人体测量测试装置颈部FEM;和一个高保真参数概率概率的人体Fem颈部已被分级验证。杂交III颈部是在汽车损伤预防研究中良好的,但已知比体内人类颈部更硬。参数化有限元基于CT扫描和解剖数据,并且模型的组件验证了组件和系统级的生物力学测试。使用基于冲击管曝光的压力历史来装载整体头颈模型。使用6英寸直径的冲击管前面的HHFEM表面的计算流体动力学(CFD)模型获得施加对这些头部模型的冲击管装载。然后将计算的压力 - 时间历史施用于头部颈部模型。将朝颈模型的全球头部旋转,压力,脑部位移和脑菌株与517至862 kPa的冲击管驱动压力进行比较。在显着的运动响应之前,在爆炸冲击后,在爆炸冲击后,在前1至5毫秒发生颅骨压力反应,在两种模型之间非常相似。在爆炸冲击后,全局头部旋转和大脑中的菌株发生在20至100毫秒,并且使用头部混合动力的模型相比,两者在模型中的模型大约高出两倍。与模型相比III颈部有限元(H3N)。还发现H2PN在H3N中未见的前10毫秒中展示了初始后向和小向下运动。增加的位移和菌株是两种组合模型之间的主要差异,表明颈部约束是通过喷枪对头部诱导的菌株引起的菌株的重要因素。因此,应在爆炸引起的脑菌株的研究中仔细控制颈部约束,但如果压力响应是主要兴趣的唯一反应参数,颈部约束不太重要。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号