【24h】

Phase Transitions in Polymers for Lithium Batteries

机译:锂电池聚合物中的相变

获取原文

摘要

The Young's modulus and the elastic energy dissipation of polyethylene oxide (PEO)-based lithium battery electrolyte membranes have been studied in this work. The membranes, formed by pure PEO and doped by LiCF_3SO_3, Li_2S and ZrO_2, were studied within a 90 K - 400 K temperature range. We observed the glass transition around 230 K and the first-order phase transformation from the crystalline to the amorphous phase around 330 K on heating. We also measured the isothermal kinetics of the transition from the amorphous to the crystalline state and found that it is slower in doped PEO. Moreover, we showed that for both samples the transformation becomes slower as the temperature increases between 319 and 331 K. The experimental results suggest that the amorphous state is stable at 331 K for a few hours before the transformation takes place. Finally, the moisture effects on the mechanical properties of pure and doped PEO membranes are reported.
机译:在这项工作中已经研究了杨氏模量和聚环氧乙烷(PEO)基锂电池电解质膜的弹性耗散。通过纯PEO形成并掺杂通过LICF_3SO_3,LI_2S和ZRO_2形成的膜在90k - 400k温度范围内。我们观察到玻璃化转变约为230 k和从结晶到加热约330k的无定形相的一阶相变。我们还测量了从非晶态到结晶状态的过渡的等温动力学,发现它在掺杂PEO中较慢。此外,我们表明,对于两个样品,转化变得慢,因为温度在319和331k之间增加。实验结果表明,在转化发生之前,无定形状态在331 k下稳定。最后,报道了对纯净和掺杂PEO膜的机械性能的水分效应。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号