首页> 外文会议>American Nuclear Society;International Conference on Environmental Degradation of Materials in Nuclear Power Systems - Water Reactors >IMPACT OF CORROSION OF NICKEL BASED COATINGS FOR FLOW ACCELERATED CORROSION CONTROL ON BWR RADIATION FIELDS
【24h】

IMPACT OF CORROSION OF NICKEL BASED COATINGS FOR FLOW ACCELERATED CORROSION CONTROL ON BWR RADIATION FIELDS

机译:镍基涂层腐蚀对BWR辐射场的流动加速腐蚀控制的影响

获取原文

摘要

Boiling water reactor (BWR) primary coolant systemradiation fields are mainly caused by the deposition ofactivated corrosion products. Co-60, formed by theneutron absorption of non-radioactive Co-59, is theradioisotope that is the main contributor to BWRradiation fields and personnel collective radiationexposure.While there are Co-59 sources within the BWRreactor vessel and reactor recirculation system, the maininput of Co-59 into the BWR reactor vessel is from thefeedwater system due to the erosion and corrosion ofvarious materials used in piping and components in thecondensate, feedwater, heater drains, and steam systems,including process valves with hard facing cobalt alloytrim. Further, materials that contain nickel, such asstainless steels and high nickel alloys (Alloys 600, 690,625, etc.), may contain a high content of Co-59, unlessspecified for low cobalt content. Raw nickel ores maycontain up to 13% cobalt (by weight).At one dual unit BWR 5, high nickel content coatingsapplied inside the high pressure turbine-moistureseparator/reheater cross-under pipes in preparation foran extended power uprate successively minimized carbonsteel flow accelerated corrosion (FAC). In the followingoperating cycle, however, an order of magnitude stepchange increase in feedwater nickel concentrationoccurred from less than 0.1 μg/L to near 1 μg/L at bothunits. Coincidentally, long term increasing trends inreactor coolant Co-60 and Co-58 concentrations wereobserved, including a nearly two orders of magnitudeincrease in Co-58 (a neutron activation product of Ni-58)and an order of magnitude increase in Co-60, leading tohigh primary system radiation fields. The forwardpumped heater drains design at these plants results in allheater drains bypassing the condensate treatment system.This paper examines why apparenterosion/corrosion of the nickel based coatings hasoccurred, how long will erosion/corrosion of the nickelcoatings continue, and what options are available formitigating nickel and cobalt ingress into the reactor fromthe feedwater system.
机译:沸水反应堆(BWR)主冷却液系统 辐射场主要是由于沉积 活化腐蚀产物。 Co-60,由 非放射性Co-59的中子吸收 放射性同位素是BWR的主要贡献者 辐射场和人员集体辐射 接触。 虽然BWR内部有Co-59信号源 反应堆容器和反应堆再循环系统,主要 Co-59向BWR反应堆容器的输入来自 给水系统由于腐蚀和腐蚀 管道和组件中使用的各种材料 冷凝水,给水,加热器排水管和蒸汽系统, 包括带有硬面钴合金的工艺阀 修剪。此外,含镍的材料,例如 不锈钢和高镍合金(合金600、690, 625等),则可能含有高含量的Co-59,除非 指定用于低钴含量。原镍矿可能 含有多达13%的钴(按重量计)。 在一个双单元BWR 5上,高镍含量的涂层 应用于高压透湿机​​内部 分离器/再热器交叉下管准备 扩展的功率提升率依次减少了碳排放 钢流加速腐蚀(FAC)。在下面的 操作周期,但是,一个数量级的步长 给水镍浓度变化增加 两者的发生率均从小于0.1μg/ L到接近1μg/ L 单位。巧合的是, 反应堆冷却剂的Co-60和Co-58浓度分别为 观察到的,包括近两个数量级 Co-58(Ni-58的中子活化产物)的增加 Co-60的数量级增加,导致 高初级系统辐射场。前锋 这些工厂的抽水式加热器排水装置设计最终实现了 加热器排水管绕过冷凝水处理系统。 本文探讨了为什么明显 镍基涂层的腐蚀/腐蚀具有 发生时,镍的腐蚀/腐蚀会持续多久 涂料仍在继续,有哪些可用选项 减少镍和钴从以下位置进入反应器 给水系统。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号