ON CATEGORIZATION OF SEISMIC LOAD AS PRIMARY OR SECONDARY FOR PIPING SYSTEMS WITH HARDENING CAPACITY

摘要

The concept of primary/secondary categorization is first reviewed and generalized for its application to a non-linear oscillator subjected to a seismic load. Categorizing the seismic load requires calculating the input level associated with the oscillator ultimate capacity and comparing it to the level associated with the plastic yield. To resolve this problem, it is assumed that the non-linear oscillator behaves like a linear equivalent oscillator, with an effective stiffness (or frequency) and an effective damping. However, as it is not a priori possible to predict the equivalent stiffness and damping, a wide range of possibilities is systematically considered. The input motion is represented by its conventional response spectrum. It turns out that key parameters for categorization are ⅰ) the "effective stiffness factor" (varying from 0 for perfect damage behaviour to 1 for elastic-perfectly plastic) and the slope of the response spectrum in the vicinity of the natural frequency of the oscillator. Effective damping and spectrum sensitivity to damping play a second order role. A formula is presented that enables the calculation of the primary part of a seismically induced stress as a function of both the oscillator and input spectrum features. The formula is also presented in the form of a diagram. This paper follows-up on a similar paper presented by the author at the PVP 2017 Conference [1]. The new development introduced here is that the oscillator exhibits hardening capacity, while no hardening was assumed in [1]. It appears that the conclusions are slightly modified but the trend is very similar to the non-hardening case. Regarding piping systems, it appears that even when experiencing large plastic strains under beyond design input motions, their observed effective frequency is very close to their natural frequency, decreasing only by a few percents (experimental data from USA, Japan and India are processed). These observations lead to the conclusion that the seismic load, or the seismically induced inertial seismic strains, should basically be regarded as secondary.