首页> 外文会议>2011 International Conference on Wireless Communications and Signal Processing >Hybrid reference signal multiplexing using combination of block spread and cyclic shift CDMA for uplink control signals in DFT-precoded OFDMA
【24h】

Hybrid reference signal multiplexing using combination of block spread and cyclic shift CDMA for uplink control signals in DFT-precoded OFDMA

机译:使用块扩展和循环移位CDMA的组合的混合参考信号复用,用于DFT预编码OFDMA中的上行链路控制信号

获取原文

摘要

This paper proposes a hybrid reference signal (RS) multiplexing scheme that employs a block spread (BS) and cyclic shift (CS) combination for the physical uplink control channel (PUCCH) in the Long-Term Evolution (LTE) uplink. In the proposed scheme, we give higher priority to BS multiplexing over the FFT blocks assigned to a RS within a slot than CS multiplexing. Hence, accurate channel estimation for coherent detection is achieved by shortening the despread interval in the frequency domain compared to the original multiplexing scheme using only CS to extract the channel estimate of each code channel. Computer simulation results show that, assuming the use of channel quality indicator (CQI) bits, the average received signal-to-noise power ratio (SNR) satisfying the required average block error rate when employing the proposed hybrid RS multiplexing is decreased compared to that for conventional RS multiplexing using only CS when the root mean square delay spread is longer than approximately 0.5 μsec particularly for a large number of multiplexed PUCCHs such as 12.
机译:本文提出了一种混合参考信号(RS)多路复用方案,其在长期演进(LTE)上行链路中采用用于物理上行链路控制信道(PUCCH)的块扩展(BS)和循环移位(CS)组合。在所提出的方案中,我们将BS多路复用的BS多路复用优先于分配给槽中的RS的FFT块而不是CS多路复用。因此,通过仅使用CS将频域中的解扩间隔缩短与原始多路复用方案仅使用CS来提取每个代码信道的信道估计来实现用于相干检测的准确信道估计。计算机仿真结果表明,假设使用信道质量指示符(CQI)比特,与此相比,在采用所提出的混合动力RS复用时满足所需平均块错误率的平均接收信号对噪声功率比(SNR)减少对于常规RS多路复用仅使用CS时,当根均方延迟扩展长于约0.5μsec,特别是对于大量多路复用的PUCCH,例如12。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号