首页> 外文会议>Ultrasonics Symposium (IUS), 2009 >Lateral motion estimator for measurement of artery-wall displacement
【24h】

Lateral motion estimator for measurement of artery-wall displacement

机译:横向运动估计器,用于测量动脉壁位移

获取原文

摘要

Artery-wall motion due to the pulsation of the heart is often measured to evaluate mechanical properties of the arterial wall. Such motion is thought to occur only in the arterial radial direction because the main source of the motion is an increase of blood pressure. However, it has recently been reported that the artery also moves in the longitudinal direction. Therefore, a 2D motion estimator is required even when the artery is scanned in the longitudinal direction because the arterial wall moves both in the radial (axial) and longitudinal (lateral) directions. Methods based on 2D correlation of RF echoes are often used to estimate the lateral displacement together with axial displacement. However, these methods require much interpolation of the RF echo or correlation function to achieve a sufficient resolution in the estimation of displacement. To overcome this problem, Jensen et al. modulated the ultrasonic field in the lateral direction at a designed spatial frequency to utilize the lateral phase for the estimation of lateral motion. This method, namely, the lateral modulation method, generates complex signals whose phases change depending on the lateral motion. Therefore, the lateral displacement can be estimated with a good resolution without interpolation, although special beamformers are required. The present paper describes a method, which can be applied to ultrasonic echoes obtained by a conventional beamformer, to estimate lateral displacements using the phases of lateral fluctuations of ultrasonic echoes. In the proposed method, complex signals were generated by the Hilbert transform, and the phase shift was estimated by correlation-based estimators. The proposed method was validated using a cylindrical phantom mimicking an artery. The error in the lateral displacement estimated by the proposed method was 13.5% of the true displacement of 0.5 mm with a kernel size used for calculating the correlation function of 0.6 mm in the lateral direction, which w-as slightly smaller than the width at -20 dB of the maximum lateral ultrasonic field (about 0.8 mm).
机译:通常测量由于心脏的搏动引起的动脉壁运动,以评估动脉壁的机械性能。认为这种运动仅在动脉径向发生,因为运动的主要来源是血压的升高。但是,最近有报道说动脉也沿纵向移动。因此,即使在沿纵向方向扫描动脉时,也需要二维运动估计器,因为动脉壁在径向(轴向)和纵向(横向)方向上均运动。基于RF回波的2D相关性的方法通常用于估算横向位移和轴向位移。但是,这些方法需要对RF回波或相关函数进行大量内插,以在位移估计中获得足够的分辨率。为了克服这个问题,詹森等人。在设计的空间频率上沿横向方向调制超声场,以利用横向相位估算横向运动。该方法,即横向调制方法,生成其相位根据横向运动而改变的复信号。因此,尽管需要特殊的波束形成器,但可以在没有插值的情况下以良好的分辨率估算横向位移。本文描述了一种方法,该方法可以应用于由常规波束形成器获得的超声回波,以利用超声回波的横向波动的相位来估计横向位移。在所提出的方法中,通过希尔伯特变换生成复杂信号,并通过基于相关的估计器估计相移。拟议的方法已验证使用模拟动脉的圆柱体模。通过所提出的方法估算的横向位移误差为0.5毫米真实位移的13.5%,其核尺寸用于计算横向方向上0.6毫米的相关函数,其中w- 略小于最大横向超声场在-20 dB时的宽度(约0.8 mm)。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号