Comparative Evaluation of Analytical Methods for the Determination of Coefficients of Friction and Stresses when Wire Rod Drawing

摘要

The article discusses the process of wire drawing of circular cross-section. The study of stresses of wire drawing in conditions of plane plastic flow was held. As theoretical framework the study was adopted the method of characteristics, a special case, having the definitive decision. Stresses during wire drawing are defined by decomposing the decision into two components of plane strain and the superposition of these decisions. The results of theoretical solution of the problem of wire drawing were used to determine the coefficients of friction on the surface of contact of the tool and the work piece during the deformation of steel with a diameter of 5.5 mm. It is recommended to use two-dimensional methods of solution in the analysis of the process of wire drawing in conditions with a high hearth of plastic deformation (with the relative height of the hearth of plastic deformation 2 and bigger). The theoretical dependences between the friction coefficients at the contact surface of the work piece and the tool was obtained. The obtained values of coefficients of friction can be used over solving the task of the wire drawing in conditions with a high hearth of plastic deformation.