首页> 外文会议>International Conference on Electrical, Computer and Communication Technologies >A novel TDOA estimation method for UHF sensor based PD localization system in HV power apparatus
【24h】

A novel TDOA estimation method for UHF sensor based PD localization system in HV power apparatus

机译:高压电力设备中基于UHF传感器的局部放电定位系统的TDOA估计新方法

获取原文

摘要

Detection and localization of Partial Discharge (PD) accurately has become an increasingly important topic for researchers in High Voltage (HV) system. PD measurement helps in condition monitoring of the total power system utilities with minimal expenditure, as it acts as an evidence to fault detection prior to outage. For complex power distribution systems, it is also very essential to locate PD coordinate exactly apart from its measurement, to identify the particular point of disorder. For accurate PD source detection and its localization, UHF signal based non-contact detecting system is proposed in this paper. In this presented work, Micro-strip Patch antenna is used as UHF sensor for detection as well as localization of PDs in HV power apparatus. A pair of sensors is being employed for detection of the same UHF PD signal, placed at different locations. These captured signal pair are then used for estimation of Time Delay of Arrival (TDOA) between two sensors by the proposed method, i.e. calculating Joint of Entropy (JE) between the signals. TDOA is further transformed into distance and used for estimation of the PD location by solving non linear equations. The K-means clustering technique is used for identifying the multiple PD sources. The experimental result proves the authenticity and efficacy of the proposed method for detection and localization of PD sources in HV power apparatus.
机译:准确地检测和定位局部放电(PD)已成为高压(HV)系统研究人员越来越重要的话题。局部放电测量有助于以最小的支出监视整个电力系统的状态,因为它可以作为停电前故障检测的依据。对于复杂的配电系统,将PD坐标准确地定位在其测量范围之外,以识别特定的混乱点也非常重要。为了精确的PD源检测及其定位,提出了一种基于UHF信号的非接触式检测系统。在本工作中,微带贴片天线用作UHF传感器,用于高压电力设备中PD的检测和定位。一对传感器用于检测放置在不同位置的同一UHF PD信号。然后,通过所提出的方法,即,计算信号之间的熵联合(JE),将这些捕获的信号对用于估计两个传感器之间的到达时间延迟(TDOA)。 TDOA被进一步转换为距离,并通过求解非线性方程式而用于PD位置的估计。 K-均值聚类技术用于识别多个PD源。实验结果证明了所提出的高压电力设备局部放电源检测与定位方法的真实性和有效性。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号