【24h】

Modular Stirling Radioisotope Generator

机译:模块化斯特林放射性同位素发生器

获取原文

摘要

High efficiency radioisotope power generators will play an important role in future NASA space exploration missions. Stirling Radioisotope Generators (SRG) have been identified as a candidate generator technology capable of providing mission designers with an efficient, high specific power electrical generator. SRGs high conversion efficiency has the potential to extend the limited Pu-238 supply when compared with current Radioisotope Thermoelectric Generators (RTG). Due to budgetary constraints, the Advanced Stirling Radioisotope Generator (ASRG) was canceled in the fall of 2013. Over the past year a joint study by NASA and DOE called the Nuclear Power Assessment Study (NPAS) recommended that Stirling technologies continue to be explored. During the mission studies of the NPAS, spare SRGs were sometimes required to meet mission power system reliability requirements. This led to an additional mass penalty and increased isotope consumption levied on certain SRG-based missions. In an attempt to remove the spare power system, a new generator architecture is considered which could increase the reliability of a Stirling generator and provide a more fault-tolerant power system. This new generator called the Modular Stirling Radioisotope Generator (MSRG) employs multiple parallel Stirling convertor/controller strings, all of which share the heat from the General Purpose Heat Source (GPHS) modules. For this design, generators utilizing one to eight GPHS modules were analyzed, which provide about 50 to 450 watts DC to the spacecraft, respectively. Four Stirling convertors are arranged around each GPHS module resulting in from 4 to 32 Stirling/controller strings. The converters are balanced either individually or in pairs, and are radiatively coupled to the GPHS modules. Heat is rejected through the housing/radiator which is similar in construction to the ASRG. Mass and power analysis for these systems indicate that specific power may be slightly lower than the ASRG and similar to the MMRTG. However, the reliability should be significantly increased compared to ASRG.
机译:高效放射性同位素发电器将在未来的NASA太空探索任务中发挥重要作用。斯特灵放射性同位素发生器(SRG)已被确认为候选发生器技术,能够为任务设计人员提供高效,高比功率的发电机。与目前的放射性同位素热电发生器(RTG)相比,SRG的高转换效率有可能扩展有限的Pu-238供应。由于预算限制,先进的斯特林放射性同位素发生器(ASRG)在2013年秋季被取消。过去一年,美国国家航空航天局(NASA)和美国能源部(DOE)联合开展了一项名为“核电评估研究(NPAS)”的研究,建议继续探索斯特林技术。在NPAS的任务研究期间,有时需要备用SRG才能满足任务电力系统的可靠性要求。这导致某些基于SRG的任务受到额外的质量惩罚并增加了同位素消耗。为了去除备用电源系统,考虑了一种新的发电机架构,该架构可以提高斯特林发电机的可靠性并提供更具容错性的电源系统。这种称为模块化斯特林放射性同位素发生器(MSRG)的新型发生器采用多个并联的斯特林转换器/控制器串,所有这些串均共享来自通用热源(GPHS)模块的热量。对于此设计,分析了使用1到8个GPHS模块的发电机,它们分别向航天器提供约50到450瓦的直流电。每个GPHS模块周围布置了四个斯特林转换器,产生了4到32个斯特林/控制器串。转换器单独或成对平衡,并且辐射耦合到GPHS模块。热量通过外壳/散热器散发,其结构与ASRG相似。这些系统的质量和功率分析表明,比功率可能会比ASRG略低,并且与MMRTG相似。但是,与ASRG相比,可靠性应显着提高。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号