首页> 外文会议>ASME international conference on ocean, offshore and arctic engineering >EXPERIMENTAL STUDY ABOUT THE INFLUENCE OF THE FREE END EFFECTS ON VORTEX-INDUCED VIBRATION OF FLOATING CYLINDER WITH LOW ASPECT OF RATIO
【24h】

EXPERIMENTAL STUDY ABOUT THE INFLUENCE OF THE FREE END EFFECTS ON VORTEX-INDUCED VIBRATION OF FLOATING CYLINDER WITH LOW ASPECT OF RATIO

机译:对浮动圆柱涡流振动的自由终止效应的影响实验研究

获取原文

摘要

Experiments regarding free-end effects on vortex-induced vibration (VIV) of floating circular cylinders with low aspect ratio were carried out in a towing tank Four cylinders with low aspect of ratio, L/D = 2 (Length /Diameter) were tested with different free end corner shape types, namely by the relation between chamfer rounding radius (r) divided by the radius of cylinder (R) (r/R = 0.0, 0.25, 0.5 and 1.0). For the initial case, r/R = 0.0 represents flat tip and r/R = 1.0 the hemispherical tip. The aims were to understand the effect of different free-end types on VIV behavior of cylinders. The floating circular cylinders, i.e. unit mass ratio m~* = 1(structural mass/displaced fluid mass) were elasti-cally supported by a set of linear springs to provide low structural damping on the system and allow six degrees of freedom. The range of Reynolds number covered 3,000 ≤ Re ≤ 20,000. To conclude, cylinder with r/R=0.25, shows lower amplitudes in transverse direction. The same occurs for the cylinder r/R = 0, but for amplitudes of vibration in in-line direction. Behaviors of the vibration frequencies in in-line and transverse direction don't have significantly differences. Regarding force coefficient, flat tip cylinder (r/R=0) presents higher values compared to the others however, for the lift coefficient, results converge in similar values for the same velocities that were observed higher transverse amplitudes. The visualization experiments show an expressive reduction of the recirculation bubble for r/R = 0.5 model compared with the flat tip, can therefore justify the lower values for this model obtained in draft amplitudes and drag coefficient compared with the flat tip model.
机译:关于具有低纵横比的涡旋型振动(VIV)对具有低纵横比的涡旋型振动(VIV)的实验,在牵引箱4个具有比率的低方面,L / D = 2(长/直径)进行了测试不同的自由端拐角形状类型,即倒角圆形半径(R)之间的关系除以气缸半径(R / R = 0.0,0.25,0.5和1.0)。对于初始情况,R / R = 0.0表示平尖,R / R = 1.0的半球尖端。目的是了解不同的自由终点类型对气缸VIV行为的影响。浮圆柱,即单位质量比m〜* = 1(结构质量/位移液质量)被一组线性弹簧弹性支撑,以在系统上提供低结构阻尼并允许六个自由度。雷诺数的范围覆盖3,000≤Re≤20,000。为了得出结论,具有R / R = 0.25的圆柱,显示横向较低的幅度。对于汽缸R / R = 0,而是发生同样的情况,但是对于在线方向上的振动的幅度。在线和横向振动频率的行为没有显着差异。关于力系数,与其他力相比,平坦尖缸(R / R = 0)呈现更高的值,但是对于提升系数,结果会随着观察到更高横向幅度的相同速度而收敛于相似的值。可视化实验表明,与平坦尖端相比,对R / R = 0.5模型的再循环气泡的表达降低,因此可以证明与平坦尖端模型相比,该模型中获得的该模型的较低值。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号