首页> 外文会议>China international conference on high-performance ceramics >Fabrication of MoSi2 Nanocrystal by Mechanical Alloying Large Particle-sized Starting Powders
【24h】

Fabrication of MoSi2 Nanocrystal by Mechanical Alloying Large Particle-sized Starting Powders

机译:机械合金化大粒径起始粉末制备MoSi2纳米晶体

获取原文

摘要

The MoSi2 nanocrystal was prepared by mechanical alloying (MA) large particle-sized starting powders,in which the milling time is much longer than usual MA time.It was found that the Mo-Si powder mixture mixed at stoichiometry proportion forms α-MoSi2 and β-MoSi2 in the MDR mode rather than pure α-MoSi2 in the SHS mode.The grain size of MoSi2,calculated using Scherrer's formula,is 18nm when milled for 96h,and decreases to 12nm when further milling to 144 h.This is because that the milling balls provide enough energy to refine most of the rough crystal grain.The average grain size increased to 15nm when milled for 192 h,which indicates that further expand time could not refine the crystal grain while cause the growth of a part of the crystal grain.The particle size of MoSi2 is about 0.5μm when milled for 96 h and the agglomerating phenomenon is severe.The particle size of MoSi2 decreases to 0.4μm and releases the agglomerating phenomenon with the milling time for 144 h.
机译:通过机械合金化大粒径的起始粉末制备MoSi2纳米晶体,其研磨时间比通常的MA时间长得多,发现以化学计量比混合的Mo-Si粉末混合物形成α-MoSi2和MDR模式下的β-MoSi2而不是SHS模式下的纯α-MoSi2。使用Scherrer公式计算的MoSi2的晶粒度在研磨96h后为18nm,而在进一步研磨至144h后减小为12nm。研磨球提供了足够的能量来细化大多数粗晶粒。研磨192小时后,平均晶粒尺寸增加到15nm,这表明进一步的扩展时间不能细化晶粒,而导致一部分晶粒的生长。研磨96 h时MoSi2的粒径约为0.5μm,团聚现象严重;随着研磨时间144h,MoSi2的粒径减小到0.4μm并释放团聚现象。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号