首页> 外文会议>14th International Power Electronics and Motion Control Conference >Wireless parallel operation of 400-Hz high-power inverters in ground power units for airplanes
【24h】

Wireless parallel operation of 400-Hz high-power inverters in ground power units for airplanes

机译:飞机地面电源装置中400 Hz大功率逆变器的无线并行操作

获取原文

摘要

This paper deals with parallel operation of 400Hz inverters in ground power units (GPU) for airplanes. For high-power 400-Hz inverters, the modulation frequency ratio is fairly low, which causes difficulties to the parallel operation. To reach low THD content in output voltage, resonant controllers are used for control of each 400-Hz inverter in the paralleled GPUs. With resonant controllers, very small phase difference between the paralleled inverters may cause huge circulating current because the output impedance is rather low. As is known, the conventional droop method has to trade off between sharing effect and voltage regulation, and effective load sharing cannot be achieved if the initial phases of the paralleled inverters are unknown. This paper proposes a novel method for parallel operation of 400-Hz inverters. Compared with the conventional droop method, the proposed method can improve the load sharing significantly together with improved dynamic response. What is more, satisfactory sharing of the power can also be achieved even under low line impedance while maintaining good frequency regulation (<1Hz). Simulation and experimental results show validity and effectiveness of the proposed method.
机译:本文介绍了飞机地面电源装置(GPU)中400Hz逆变器的并行操作。对于大功率400 Hz逆变器,调制频率比相当低,这给并联操作带来了困难。为了在输出电压中达到较低的THD含量,谐振控制器用于控制并行GPU中的每个400 Hz逆变器。对于谐振控制器,由于输出阻抗相当低,因此并联逆变器之间的很小的相差可能会导致巨大的循环电流。众所周知,传统的下垂方法必须在共享效果和电压调节之间进行权衡,如果并联逆变器的初始相位未知,则无法实现有效的负载共享。本文提出了一种用于400 Hz逆变器并联运行的新方法。与传统的下垂方法相比,该方法可以显着改善负载分配并改善动态响应。而且,即使在低线路阻抗的情况下,也可以实现令人满意的功率共享,同时保持良好的频率调节(<1Hz)。仿真和实验结果表明了该方法的有效性和有效性。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号