Analysis of Highwall Mining Stability - The Effect of Multiple Seams and Prior Auger Mining on Design

摘要

The objective of this is paper is to review the current state of knowledge and practice in highwail mining (HWM) HWM has become a standard method in surface mining, commonly used alone or in conjunction with contour or slot mining. It provides 800-feet to 1,200-feet of additional recovery when the economic stripping ratio is reached in contour mining or in slot mining when surface access to a reserve is limited A significant attribute of the highwail miner is its versatility HWM has been used successfully to mine 1. abandoned pie-reclamation law highwalls, 2. points or ridges uneconomic to mine by underground or other surface methods, 3. outcrop barriers left adjacent to underground mines, 4. separate benches of the same seam where the parting thickness or quality differences between benches render complete extraction uneconomic, 5. previously augered areas containing otherwise inaccessible additional reserves and 6. close or widely spaced multiple seams The theory and design methods to assess roof, pillar, and floor stability are presented followed by three case histories Simple design charts for sizing HWM web and barrier pillars are also presented A recommended web pillar width may be obtained from the design charts given the overburden depth, the HWM cut width, and the mining height Given the depth and panel width for a set of HWM cuts, another set of charts gives a suggested barrier pillar width. The case histories, from Northern and Southern Appalachia are used to illustrate the application of rock mechanics to quantify the stability of the highwail, roof, web pillars, and floor. The case histories involve 1) mining through a previously augered highwail, 2) mining under back-stacked spoil and 3) selective mining of closely spaced benches of the same seam. Because each site is unique, the appropriate pre-mining geotechnical analyses range from the calculation of roof, web pillar, and floor bearing capacity stability factors to detailed numerical modeling of the auger and underground mine workings When operating in the vicinity of existing underground mine or auger workings, the determination of ground deformation and strains resulting from highwail mining is a necessary facet of a ground control investigation.