Way of LEEPL Technology to Success in Memory Device Application

摘要

Lithography for 65nm-node device is drawing a lot of attentions these days especially because lithography solution for this node is not clear and even tool makers tend to wait for the consensus in lithography roadmap to avoid the risk of erroneous amount of investment. Recently proposed concept of low energy electron-beam proximity-projection lithography (LEEPL) technology has already released its first production machine in 2003, which is being expected to cover the design rule down to 65nm-node and even smaller. Although production of semiconductor device has been pursuing optical lithography, without any optical technology that is proved as a convincing solution for 65nm node and below, we need to take account of all the candidates. So we made an investigation on LEEPL technology and evaluated beta and first production tool to see the feasibility of printing sub-70nm resolution and of optic-first mix-and-match overlay from a chip maker's point of view. Two different kinds of stencil masks were fabricated for the evaluation, which are fabricated in SiC and Si membrane. The former mask is for sparse contact holes(C/H) and the latter for dense C/Hs. Beta-tool showed a good resolving power of sub-70nm sparse C/Hs of SRAM with negligibly small proximity effect. It implies that LEEPL does not require much effort for proximity correction comparing to that required in optical lithography, which is one of the biggest issues in low-k1. LEEPL also showed a good capability of optic-first mix-and-match overlay correction and this is the most stringent and important functionality for optic-first mix-and-match application. However random intra-membrane image placement(IP) error that is a little bit larger than the requirement for sub-70nm node was observed, which is interpreted to come from the larger stress of 100MPa in 3X3 mm~2 dry-etched SiC unit membrane. For dense C/Hs, we failed, to the contrary, to obtain any good quality of stencil masks for DRAM cell patterns because of e-beam proximity effect which is unavoidable in the reversed order of front-side forward direct writing and back-side later membrane formation. Pros and cons of LEEPL technology are discussed based on the evaluation results and estimation from the memory device standpoint. We also propose a novel concept of stencil mask that can be helpful in memory device application.