【24h】

Scattering-induced downstream beam modulation by plasma scalded mirrors

机译:等离子体缩放镜对散射引起的下游光束调制

获取原文
获取原文并翻译 | 示例

摘要

Previous work concluded that plasma scalds on laser-conditioned multilayer dielectric mirror coatings are a stable, benign damage morphology. Recent large-aperture measurements indicate that plasma scalds may lead to fratricide of down-stream optics by increasing beam contrast. This paper describes the results of measurements performed to examine the effect of quasi-periodic plasma scalds covering the entire clear aperture on downstream beam modulation. A collimated, linearly-polarized 1053-nm beamline was constructed that irradiated approximately 5 cm~2 of the plasma scalded region. This beam was propagated ~8 meters and sampled with a 10-bit, megapixel CCD camera and analyzed for contrast (peak/average intensity). A lineout across the sample was built up by translating the optic across the beam. The contrast results were compared to a baseline wedged flat with surface figure of λ/100 and a contrast adder for the plasma scalds calculated. This was defined by . In all, optics with average plasma scald fractions of 0.9, 2.3, 4 and 14% were measured. Preliminary results indicate that plasma scald fractions of 4% and below contribute a contrast adder of less than 2.5%.
机译:先前的工作得出的结论是,在经过激光处理的多层介电镜涂层上的等离子体烫伤是一种稳定的良性损伤形态。最近的大口径测量表明,等离子体烫伤可能会通过增加光束对比度而导致下游光学器件的爆炸。本文介绍了测量结果,以检查覆盖整个净孔径的准周期等离子体烫伤对下游光束调制的影响。构造了准直的线性偏振的1053 nm光束线,该光束线照射了大约5 cm〜2的等离子体氧化皮区域。该光束传播至约8米,并用10位百万像素CCD相机采样,并进行对比度(峰值/平均强度)分析。通过将光学器件平移到光束上,可以建立整个样品的划线。将对比结果与具有λ/ 100表面图形的基线楔形平板进行比较,并计算出用于血浆烫伤的对比加法器。由定义。总共测量了平均等离子体缩放比例为0.9%,2.3%,4%和14%的光学元件。初步结果表明,血浆烫伤率在4%及以下时,造影剂的添加量小于2.5%。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号