首页 > 标准详情页 > Standard Test Methods for Nickel in Water

Standard Test Methods for Nickel in Water

机译:水中镍的标准试验方法

获取原文

摘要

1.1These test methods2,3,4cover the atomic absorption determination of nickel in water and wastewaters. Three test methods are given as follows:ConcentrationRangeSectionsTest Method A—Atomic Absorption,  Direct0.1 to 10 mg/L7 –16Test Method B—Atomic Absorption,  Chelation-Extraction10 to 1000 μg/L17 –26Test Method C—Atomic Absorption,  Graphite Furnace5 to 100 μg/L27 –361.2Test Methods A, B, and C have been used successfully with reagent grade water and natural waters. Evaluation of Test Method C was also made in condensate from a medium Btu coal gasification process. It is the user's responsibility to ensure the validity of these test methods for other matrices.1.3The values stated in SI units are to be regarded as standard. The values given in parentheses are mathematical conversion to inch-pound units that are provided for information only and are not considered standard.1.4This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.For specific hazards statements, seeNote 5,11.8.1,21.11,23.7, and23.10.1.5Two former colorimetric test methods were discontinued. Refer toAppendix X1for historical information.1.6This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. ====== Significance And Use ======4.1Elemental constituents in potable water, receiving water, and wastewater need to be identified for support of effective pollution control programs. Test Methods A, B, and C provide the techniques necessary to make such measurements.4.2Nickel is considered to be relatively nontoxic to man and a limit for nickel is not included in the EPA National Interim Primary Drinking Water Regulations.6The toxicity of nickel to aquatic life indicates tolerances that vary widely and that are influenced by species, pH, synergistic effects, and other factors.4.3Nickel is a silver-white metallic element seldom occur-ring in nature in the elemental form. Nickel salts are soluble and can occur as a leachate from nickel-bearing ores. Nickel salts are used in metal-plating and may be discharged to surface or ground waters.
机译:1.1这些试验方法2.,3.,4.涵盖水和废水中镍的原子吸收测定。三种试验方法如下:浓度范围小节试验方法A-原子吸收, 直接的0.1至10毫克/升7 –16试验方法B-原子吸收, 螯合萃取10至1000微克/升17 –26试验方法C-原子吸收, 石墨炉5至100微克/升27 –361.2试验方法A、B和C已成功用于试剂级水和天然水。在中等Btu煤气化过程的冷凝液中也对试验方法C进行了评估。用户有责任确保这些测试方法对其他矩阵的有效性。1.3以国际单位制表示的数值应视为标准值。括号中给出的值是英寸-磅单位的数学转换,仅供参考,不被视为标准值。1.4本标准并非旨在解决与其使用相关的所有安全问题(如有)。本标准的用户有责任在使用前制定适当的安全、健康和环境实践,并确定监管限制的适用性。有关具体危害说明,请参阅附注5,11.8.1,21.11,23.7和23.10.1.5停止使用以前的两种比色试验方法。提到附录X1以获取历史信息。1.6本国际标准是根据世界贸易组织技术性贸易壁垒(TBT)委员会发布的《关于制定国际标准、指南和建议的原则的决定》中确立的国际公认标准化原则制定的。====意义和用途======4.1需要确定饮用水、受纳水和废水中的元素成分,以支持有效的污染控制计划。试验方法A、B和C提供了进行此类测量所需的技术。4.2镍被认为对人体相对无毒,并且镍的限量不包括在EPA国家临时初级饮用水法规中。6.镍对水生生物的毒性表明,耐受性差异很大,受物种、pH值、协同效应和其他因素的影响。4.3镍是一种银白色金属元素,在自然界中很少以元素形式出现。镍盐是可溶的,可以作为含镍矿石的渗滤液出现。镍盐用于金属电镀,可排放到地表水或地下水。

著录项

  • 标准号ASTM D1886-14(2021)e1

    标准状态现行

  • 发布单位或类别美国-美国材料与试验协会(US-ASTM);

    发布日期2021-11-01

  • 实施日期

    废止日期

  • CCS分类

    ICS分类13.060.50 水质 - 水的化学物质检验

  • 其他编号ASTM D1886-14(2021)e1

  • 起草单位

  • 起草人

  • 归口单位 D19.05

关联关系

  • 代替如下标准
  • 被如下标准代替
  • 引用下列标准
  • 采用如下标准
  • 0.ASTM D1886-14

获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号