Disclosed herein is a vibrational air mover that is open on both ends with eye shaped openings. There is a cable pulled tight from corner to corner of the eye shaped openings on both ends. The two eye shaped pieces are connected to each other with iron rods, the rods connect to the corners of the eye shaped pieces. This forms a rectangular shape with openings on each end. There is a cable running from corner to corner of the eye shaped openings, connecting to the center of these two cables is an additional cable that runs the length of the air mover. The eye shaped pieces are made of a flexable material, such as stainlesss steal. The frame work is then covered with material rip stop nylon is sewn to the eye shaped pieces and the iron rods it needs to be pulled tight as it is sewn on. Then the material is doped with air craft dope or butyrate dope to pull the material drum tight. Then the weight bearing cable is attached, it is attached to the front eye shaped piece in the center of the cable. The weight bearing cable has a weight attached at the half way point between the handle or lever and the front eye shaped opening. When the weight bear bearing cable comes tight it goes into a state of vibration, the vibration releases friction inside the air mover allowing the air inside the air mover to move freer. The air mover is placed inside the wing of the air craft, the wing has openings on the top of the wing that allows air to pulled inside the wing, there are also openings on the bottom of the wing to allow air to escape or leave the wing. The vibration moves the eye shaped pieces slightly opening and closing them, this causes small volumes of air to move down the air mover, although the volumes being moved are small due to the fact that they are being caused by the vibration means that there are many small volumes of air bieng moved, and at a rapid and repitious rate, this coupled with the release of friction and the fact that once the vibration begins as far as the air outside of the wing of the air craft is concerned there is an inbalance taking place the air inside the wing of the air craft is lacking in volume or in a state of vacuum, and the air outside rushes in to fill the vacuum or void, to try to balance the two volumes of air. This is how a large amount of air can be moved in a short period of time and with a minimal amount of effort.
展开▼