首页>
外国专利>
Device for emptying of residual material from plastic tube consists of high grade steel wire which is about 24 cm. long, 1 mm. thick, and bent by 90 degrees, with another bend of 90 degrees after about 15-20 mm, forming U with unequal sides
Device for emptying of residual material from plastic tube consists of high grade steel wire which is about 24 cm. long, 1 mm. thick, and bent by 90 degrees, with another bend of 90 degrees after about 15-20 mm, forming U with unequal sides
The device for the emptying of residual material from a plastic tube consists of high grade steel wire which is about 24 cm. long, 1 mm. thick, and bent at a right angle by 90 degrees. After about 15-20 mm. there is another bend of 90 degrees, forming a U with unequal sides. The U lies on a working plate, and the steel wire measured down the long side from the last bend is bent again by 90 degrees, and then after another 5 mm. there is another bend of 90 degrees so that another U with unequal sides is described. On the long side a bend of 2 x 90 degrees is applied which has an inside diameter/clear width of about 1.5 - 2 mm.
展开▼
机译：用于从塑料管中排空残留材料的设备由大约24厘米的高级钢丝组成。长1毫米。厚，并以90度直角弯曲。约15-20毫米后。还有另一个90度的弯曲，形成一个不等边的U。 U位于工作板上，从最后一个弯头沿长边向下测量的钢丝再次弯曲90度，然后再弯曲5毫米。还有另一个90度的弯曲，因此描述了另一个U边不相等的情况。在长边上施加2 x 90度的弯曲，其内径/净宽度约为1.5-2 mm。
展开▼
