Sidewall Boundary Layer Corrections in Subsonic, Two-Dimensinal Airfoil/Hydrofoil Testing

摘要

Historically, two-dimensional airfoil or hydrofoil section characteristics have been obtained by measuring individually the lift, drag and pitching moment by the most accurate technique available. The use of force balances to measure the three quantities simultaneously has met with only partial success. although the lift and pitching moment data have usually been acceptable, the drag data have varied by as much as an order or magnitude from previous reference data. To investigate the parameters which influence two-dimensional force measurements, an experimental program was conducted in the subsonic wind tunnel of the Applied Research Laboratory at The Pennsylvania State University. From the results of this test program, the sidewall boundary layer was identified as the primary factor contributing to the erroneous drag measurements. A correction procedure which is based on the airfoil/hydrofoil geometry, the flow environment and the measured data was developed. Corrected data from the subject test probram and from similar programs in other experimental facilities for both symmetrical and cambered sections are in good agreement with the reference data in all cases. (Author)