首页> 外文期刊>Solid state ionics >Direct operation of solid oxide fuel cells with methane fuel
【24h】

Direct operation of solid oxide fuel cells with methane fuel

机译:固体氧化物燃料电池与甲烷燃料直接运行

获取原文
获取原文并翻译 | 示例
获取外文期刊封面目录资料

摘要

The operation of Ni-YSZ anode supported SOFCs on methane fuel is described. Power densities as high as 0.52 W/cm(2) at 700 degrees C and 1.27 W/cm(2) at 800 degrees C were observed. Open circuit voltages (OCV) increased with increasing temperature to nearly 1.2 V, in good agreement with equilibrium calculations. Measurements of direct-methane SOFC stability showed that at lower temperatures, <= 700 degrees C, stable operation without coking occurred over a wide range of current densities. At higher temperatures, increasingly large currents were required to avoid cokin and cell failure. In electrochemical impedance spectra, two electrode arcs were observed with the higher frequency arc increasing in size when the fuel was switched from hydrogen to methane. Mass spectrometer measurements showed that the expected reaction products-H-2,H- H2O, CO, and CO2-all increased with increasing cell current density. The dominant products at 800 degrees C were H-2 and CO, in agreement with thermodynamic predictions. Reasons for stable coke-free direct methane operation are discussed. (c) 2005 Elsevier B.V. All rights reserved.
机译:描述了Ni-YSZ阳极负载的SOFC在甲烷燃料上的操作。在700摄氏度时的功率密度高达0.52 W / cm(2),在800摄氏度时的功率密度高达1.27 W / cm(2)。开路电压(OCV)随着温度的升高而增加到接近1.2 V,这与平衡计算非常吻合。直接甲烷SOFC稳定性的测量结果表明,在<= 700℃的较低温度下,在很宽的电流密度范围内都能稳定运行而不会结焦。在更高的温度下,需要越来越大的电流来避免cokin和细胞衰竭。在电化学阻抗谱中,观察到两个电极电弧,当燃料从氢转换为甲烷时,高频电弧的尺寸增大。质谱仪测量表明,预期的反应产物-H-2,H- H2O,CO和CO2-均随着电池电流密度的增加而增加。与热力学预测一致,在800摄氏度下的主要产物是H-2和CO。讨论了无焦炭直接甲烷稳定运行的原因。 (c)2005 Elsevier B.V.保留所有权利。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号