...
首页> 外文期刊>Journal of analytical & applied pyrolysis >Effect of secondary gas-phase reactions (SGR) in pyrolysis of carbon feedstocks for anisotropic carbon materials production-3: Modifying non-coking coal tar through co-pyrolysis of coal with linear low-density polyethylene and high-impact polystyrene
【24h】

Effect of secondary gas-phase reactions (SGR) in pyrolysis of carbon feedstocks for anisotropic carbon materials production-3: Modifying non-coking coal tar through co-pyrolysis of coal with linear low-density polyethylene and high-impact polystyrene

机译:

获取原文
获取原文并翻译 | 示例
   

获取外文期刊封面封底 >>

       

摘要

This work focuses on co-pyrolysis experiments of Utah Sufco coal with linear low-density polyethylene (LLDPE) and high-impact polystyrene (HIPS). These two plastic types have differing pyrolysis chemistries and have different hydrogen transfer behavior. Similar to earlier work in this series of papers, controlled secondary gas-phase reactions during pyrolysis were used to induce cracking and condensation reactions among the pyrolytic tar species. Co-pyrolysis tests were performed with feed plastic percentages ranging from 10 to 20 wt and pyrolysis SGR temperatures ranging from 800 to 900 degrees C. Analyses of the intermediate tar products showed that oxygen contents and aromaticity were substantially different, depending on the plastic, and resulting pitch softening points and mesophase contents also varied greatly depending on the starting plastic feedstock used. Most of the synergies observed in the co-pyrolysis results were negative, except for the oxygen content. Oxygen contents were higher than expected when LLDPE was used, resulting in reactive pitches with softening points >350 degrees C. On the other hand, oxygen contents were lower than expected when HIPS was used, resulting in less reactive pitches. Ultimately, only the HIPS/coal samples created at the SGR temperature of 900 degrees C had reasonable softening points at or under 350 degrees C, making them the only samples created in this work potentially suitable for mesophase pitch-based carbon fiber production. The success in creating fusible mesophase pitches from co-pyrolyzing HIPS with Utah Sufco coal is likely attributed to the fact that polystyrene is a stronger hydrogen acceptor rather than donor, which should facilitate more cracking rather than stabilizing tar oxygen functional groups, making the tar species ultimately less reactive during thermal conversion to mesophase pitch.

著录项

相似文献

  • 外文文献
  • 中文文献
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号