Creep of die-cast Mg alloys is described as an integral part of their plastic deformation behavior in terms of stress-strain-rate-strain relations. Creep tests yield information on yield stress, work hardening, maximum deformation resistance (minimum creep rate), and work softening. Testing in compression avoids influences by fracture. Data on the alloy AJ52 (5A1, 2Sr) in the temperature range between 135 deg C and 190 deg C are presented and compared to those for AZ91 and AS21. Die-cast Mg-Al alloys consist of fine grains with a grain boundary region containing intermetallic precipitates. Transmission electron microscopic observations indicate that basal glide is the dominant mechanism of deformation being supplemented by nonbasal glide and twinning to maintain compatiblity between the grains. The deformation resistance can be modeled with a composite approach assuming that the grain boundary region is relatively hard due to precipitation of intermetallic phases. The differences in long-term creep resistance at low stress are explained in terms of different strength and stability of precipitates in the different alloys.
展开▼
