Evaluation of fiber surfaces treatment and sizing on the shear and transverse tensile strengths of carbon fiber‐reinforced thermoset and thermoplastic matrix composites

摘要

AbstractThe mechanical performance of advanced composite materials depends to a large extent on the adhesion between the fiber and matrix. This is especially true for maximizing the strength of unidirectional composites in off‐axis directions. The materials of interest in this study were PAN‐based carbon fibers (XA and A4) used in combination with a thermoset (EPON 828 epoxy) and a thermoplastic (liquid crystal poymer) matrix. The effect of surface treatment and sizing were evaluated by measuring the short‐beam shear (SBS) and transverse flexural (TF) tensile strengths of unidirectional composites. Results indicated that fiber surface treatment improves the shear and trasverse tensile strengths for both thermosetting and thermoplastic matrix/carbon fiber‐reinforced unidirectional composites. A small additional improvement in strengths was observed as the result of sizing treated fibers for the epoxy composites. Scanning electron microscope photomicrographs were used to determine the location of composite failure, relative to the fiber‐matrix interface. Finally, the epoxy composites SBS and TF strengths appear to be limited to the maximum transeverse tensile strength of the epoxy matrix, while the thermoplastic composite SBS and TF strengths are limited by the LCP matrix shear and transverse tensile strengths, res