首页> 外文期刊>Carbon: An International Journal Sponsored by the American Carbon Society >THE EFFECT OF GRINDING ON THE SINTERING OF RAW PETROLEUM COKE
【24h】

THE EFFECT OF GRINDING ON THE SINTERING OF RAW PETROLEUM COKE

机译:研磨对原料石油焦烧结的影响

获取原文
获取原文并翻译 | 示例
获取外文期刊封面目录资料

摘要

Preparation of dense carbon materials without use of any binder was attempted, effect of grinding treatment on the characteristics of raw petroleum needle coke and on the properties of the sintered carbon compacts was investigated, and the sintering mechanizm of the coke after grinding was discussed. It was found that the coke particle size and crystalline size was decreased and the specific surface area of the coke was increased with grinding, and the influence was obvious up to 20 hours grinding treatment. The interlayer spacing of the coke after graphitization at 2773 K was gradually increased and the a-axis constant was marginally reduced with the grinding time. Results from the sintering experiment show that carbon materials can be sintered from the ground coke, and the density and flexural strength of the sintering compacts reached stable values of 1.8 g cm(-3) and about 70 MPa, respectively, after 20 hours grinding of the coke. The sintering ability of the coke after grinding was considered to result from the increase of surface energy, lattice distortion energy and fraction of volatile matters of the coke, which were induced by grinding treatment. (C) 1997 Elsevier Science Ltd References: 14
机译:尝试在不使用任何粘结剂的情况下制备致密碳材料,研究了研磨处理对原料石油针状焦特性和烧结碳致密性性能的影响,并探讨了研磨后焦炭的烧结机理。结果表明,随着研磨,焦炭粒径和结晶粒度减小,焦炭比表面积增大,长达20小时的研磨处理影响明显。石墨化后焦炭在2773 K的夹层间距逐渐增大,a轴常数随研磨时间的延长而略有减小。烧结实验结果表明,磨焦后,碳材料可以从磨碎的焦炭中烧结,烧结压块的密度和抗弯强度分别达到1.8 g cm(-3)和约70 MPa的稳定值。认为磨焦后焦炭的烧结能力是磨化处理诱导焦炭表面能、晶格变形能和挥发物分数增加的结果。(C) 1997 Elsevier Science Ltd [参考文献: 14]

著录项

获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号