Electrical/flow heterogeneity of gas diffusion layer and inlet humidity induced performance variation in polymer electrolyte fuel cells

摘要

A three-dimensional single-flow channel computational model is used to investigate the performance characteristics of polymer electrolyte fuel cells (PEFC). The combined influence of non-uniform interfacial contact resistance (ICR) and inlet relative humidity (RH), along with the heterogeneous flow properties of the gas diffusion layer (GDL) on the PEFC performance is evaluated. The study considers combinations of full and partial humidification of anode and cathode reactants. Results reveal heterogeneous GDL with nonuniform ICR distribution results in a slight -4.4 reduction in current density at 0.3V compared to the homogeneous case. However, under same electrical/flow heterogeneities, the current density is observed to increase by -19 to -1.3A/cm2 under fully humidified anode and partially humidified cathode (i.e., RHaRHc = 10060) as compared to -1.1A/ cm2 under symmetric RHaRHc = 100100. Interesting observations are made on the temperature distribution and cathodic water fractions. The variation in anodic inlet humidity is observed to have no impact on temperature distribution in the membrane, whereas variation in cathodic inlet humidity is effective in reducing the temperature in the channel regime with a 4K (kelvin) difference among all the cases. It is noted here that the overpotential map is not an indicator for performance loss, at least at full inlet humidity. This parameter is observed to depend on water concentration in the cathode. The study provides a detailed analysis of the distribution of reactant mass fraction, water concentration, current density, temperature, cathodic overpotential, and cell performance for all the simulated cases. (c) 2022 Hydrogen Energy Publications LLC. Published by Elsevier Ltd. All rights reserved.