Study on the scanning protocols for measuring bone mineral density by gemstone CT spectral imaging based on European spine phantom

摘要

Background Gemstone spectral computed tomography (GSCT) has been used to measure bone mineral density (BMD) in human vertebrae and animal models gradually. Purpose To investigate the effect of scanning protocols for BMD measurements by GSCT using the European spine phantom (ESP) and its accuracy and precision. Material and Methods The ESP number 145 containing three hydroxyapatite (HAP) inserts with densities of 50, 100, and 200 mg/cm(3) were labeled as L-1, L-2, and L-3, respectively. Quantitative CT (QCT) protocol and 14 groups of scanning protocols configured by GSCT were used to repeatedly scan the ESP 10 times. Their measurements were compared with the true values of ESP and their relative standard deviation and relative error were calculated. Results The measured values of the three inserts at different exposure levels were statistically significant (P < 0.05). The measured values in the 0.8 s/r 260 mA group, 0.5 s/r 630 mA group, and 0.6 s/r 640 mA group were not significantly different from the actual ESP values for L-1 and L-2. However, the measured values at all the parameters were significantly different from the actual values for the L-3. Conclusion CT gemstone spectral imaging can accurately and quantitatively measure the HAP value of ESP, but the results of BMD will be affected by the scanning protocols. The best scanning parameter of ESP measured by GSCT was 0.8 s/r 260 mA, taking dose into consideration, and the measurement accuracy of vertebrae with low BMD was higher than that of QCT under this parameter.