AbstractAcid‐base interaction parameters were measured by inverse gas chromatography over broad temperature ranges for Poly(vinyl chloride), plasticizer, and CaCO3fillers. Mixing was performed by three routes. In one, all components were added simultaneously, while in others two of the components were premixed, the third ingredient being added subsequently. Mixing was carried on to equilibrium torque readings. The energy requirement for mixing was found to depend on the interaction balance among the components, and to vary with the procedure selected. Minimum requirement was associated with the simultaneous introduction of all ingredients. Higher energies were needed in sequential mixing schemes, presumably because equilibrium partitioning of components was hindered in these instances. Initial mechanical properties of the compounds did not vary greatly with preparation procedure, but upon aging, mechanical property variations became quite evident. Component repartitioning, driven by shifting interaction balances at aging and at test (room) temperatures are cited as responsible. The kinetics of attaining equilibrium mechanical properties also were found to vary with mixing procedure and to respond to the interaction balance concep
展开▼
